Unpacking And Operation - Christopeit Sport RPT 6200 Montage- Und Bedienungsanleitung

UNPACKING AND OPERATION

Before usage, observe our recommendations and safety instructions.
STEP1:
Remove the treadmill (1).
1. Remove small parts, loose packing material out of the box and
then take out with help of a second person the preassembled frame
of packaging. Put your hands below the main frame (1) and take care
of no squeezing.
STEP 2:
Unfolding the support tubes (3+4)
1. Fold up the supports left and right (3+4). Support the two sup-
ports (3+4) with your hand to avoid falling and the associated risk of
injury. Fasten this in an upright position by screwing in the screws
(30) using the allen key (12) and then tighten the rotary knob (105).
(Make sure that the teeth match with each other at both sides.)
STEP3:
Positioning the handles (6+7) and the computer (5).
ATTENTION: When assembly the hand bar, please attention the hole
on the hand bar is downward.
1. Put the left handle (6) with holder at the left sidepost (3). Use small
rotary knob (57) with nylon washer (34) to lock the handle tightly.
2. Put the right handle (7) at right sidepost (4).
3. After using for a time, if the handle is loose, please fasten the rota-
ry knob (57) again.
4. Flip the computer (5) until the positioning pin (62) pops in.
5. Remove the protective film from the display if present.
6. Insert the tab holder (65) into the slot on the top of the computer
(5).
14
GB