Maintenance And Adjusting - Christopeit Sport CS3000 Montage- Und Bedienungsanleitung

MAINTENANCE AND ADJUSTING

Lubrication for the running belt
In order to keep the machine in the best condition, please
add some Silicone oil between the running belt and the
running board after 50 hours of use. But the running belt
may slip, if you lubricate too much. To lubricate the belt
please pull the walking belt up and injection the silicon spray
or silicone oil into the gap between belt and walking deck.
(Attention: Too much lubricant can cause the tread to slip.)
Adjusting running belt
You need to adjust the walking belt to the normal position, per
the following steps if it is off.
a. Set speed at 3-5km.
b. Using the Allen key to adjust the belt tension bolt on the end
cap of the system frame.
c. If you want to move the belt towards left, turn the right
tension bolt clockwise.
d. If you want to move the belt towards right, turn the left
tension bolt clockwise.
e. If you have already done according to the steps above and
it is still not at the good range, then the running belt should be
damaged already, please contact your local dealer for replace-
ment.
Note: Make sure that the running surface is as centered as
possible. Once these moves too far from the center, (about 10
mm) it should be readjusted into the center.
Running belt slips
a. Make sure the walking belt is not too loose.
b. Make sure the motor belt is not too loose.
c. Remove excess lubricant with a cloth.
No light on the Display
a. Check whether the plug is in the socket and whether the
outlet has power.
b. Check that the main switch on the base frame is switched on
and that the safety clip is correctly attached to the computer.
Attention! Always pull out the mains plug when checking the
computer plug connections.
c. Check whether the overload protection has tripped. If
necessary, press the button.
Abnormal noise from the machine:
a. Check if any screw of machine is loose.
b. Check if the motor belt is off.
c. Check if the running belt is off.
Note: Please contact your local dealer if you have checked all
the above listed things but the problem is still there.
Cleaning
Use only a less wet cloth for cleaning. Caution: Never use
benzene, thinner or other aggressive cleaning agents for
surface cleaning as this damage caused. The device is only for
private home use and for use suitable indoors. Keep the unit
clean and moisture from the device.
Storage
Fold up the treadmill. Unplug the power cord if you do not
intend to use the device for more than 4 weeks. Choose a dry
storage location in the house. Cover the device to protect it
from discoloration caused by sunlight and dust.
b.
b.
c.
a.
15
GB
c.
d.