Maintenance And Adjusting - Christopeit Sport TM780S Montage- Und Bedienungsanleitung

Maintenance and adjusting

1. Lubrication for the running belt:
To ensure that the treadmill runs light and well over long term,
the backside of running surface should always checked for
lubricity and, if necessary, treated with silicone oil (no lubricant
based on oil or petroleum). When using less than 3 hours / week,
we recommend lubricating once a year, when using 3-4 hours
/ week, every six months and when using more than 5 hours /
week, lubricate every three months. The lubrication takes place
by the put in silicone oil into the maintenance opening. To do this,
start the treadmill at a slow speed, remove the rubber plug, and
dribble some silicone oil (approx. 5ml) into the opening. (Caution:
Too much lubricant may cause the tread to slip.)
2. Adjusting running belt:
You need to adjust the walking belt to the normal position, per
the following steps if it is off.
1. Set speed at 3-5km.
2. Using the allen wrench (25) for running belt adjustment to
adjust the belt tension bolt on the end cap of the system frame.
3. If you want to move the belt towards left, turn the right tension
bolt clockwise.
4. If you want to move the belt towards right, turn the left tension
bolt clockwise.
5. If you have already done according to the steps above and
it is still not at the good range, then the running belt should be
damaged already, please contact your local dealer for replace-
ment.
Note: Make sure that the running surface is as centered as possible. Once
these moves too far from the center, (about 10 mm) it should be readjusted
into the center.
3. Running belt slips:
1. Make sure the walking belt is not too loose.
2. Make sure the motor belt is not too loose.
4. No light on the Display:
1. Check if the power plug is properly connected.
2. Check if the safety key on the computer is in place.
3. Check if the wire in the right post is properly connected.
Remind ! Before you inspect any wire or electrician part, ple-
ase ensure that the Power supply has been turned off.
5. Abnormal noise from the machine
1. Check if any screw of machine is loose.
2. Check if the motor belt is off.
3. Check if the running belt is off.
Note:
Please contact your local dealer if you have checked all the above
listed things but the problem is still there.
Open the oilplug
18
Insert the bottle into
the oil port.