Christopeit Sport RPT 6200 Montage- Und Bedienungsanleitung Seite 18

Safety clip
The safety clip has an emergency function. In fear or danger or if you
fall down or jumped from it, the safety clip will lose position at compu-
ter and stops the motor with break system. Put the safety key out from
computer on any status, the display is „- - -", the buzzer beeps each se-
cond. Put the safety key on computer, then the display will enter nor-
mal manual mode. All parameter reset to zero.
Before training, test the function of the safety clip. To do this, start the
treadmill at the lowest speed and then pull out the safety clip. The tre-
admill must stop immediately.
Remind add oil function
When the treadmill in running sate, the total distance more than
100KM, the time windows will show time and OIL take turns, and have
the buzzer sounds, it reminds the user need add the oil. At this state,
press [STOP] button can eliminate the reminder and zero the cumula-
tive distance. In addition, pull out the safety key, press the [EINGABE]
and [PROG] more than 3 seconds will show cumulative distance. If you
want eliminate, press the [EINGABE] and [PROG] more than 3 seconds
again.
Hibernation
If the treadmill is not in use the display switch off into Standby Mode.
PULSE
Cardio Pulse measurement:
For pulse measurement, the pulse measuring unit 9309 must be in pla-
ce. The use of the pulse measuring unit makes it possible for you to
accurately monitor your own training programme by exact, real-time
measurement of your heart rate. The installation of the system is very
simple and easily done.
The pulse measuring unit was developed especially for use with this
machine. The user puts on the unit and the transmitter of the unit re-
gisters the ECG signals of the heart. The transmitter amplifies the ECG
signals and transmits them in the form of radio signals to the receiver
installed in the computer.
The transmitter switches on automatically when the pulse measuring
unit is put on and the rear of the pulse measuring unit have made con-
tact with the breast. Any kind of normal training clothes may be worn
over the pulse measuring unit. The receiver installed in the computer
receives the signals from the transmitter and transfers these in the
form of electrical impulses to the computer. The computer processes
the signals and displays them as pulse beats per minute on the display.
To attain an optimum performance of the pulse measuring unit, the
machine should be set up for training in such a manner that it is as far
as possible from all high-voltage power lines, electric motors and other
sources which can cause interference. Adjust the strap to your chest
measurement and put on the entire unit as depicted in the illustration.
Ensure that the strap is not too loose and that the transmitter is loca-
ted at the centre of your chest. The unit and thereby the pulse measu-
ring system is then installed and ready for use.
Clean the pulse measuring unit after each training session with a cloth
moistened with a soap solution and then with a cloth moistened with
pure water. This prevents the accumulation of sweat which could lead
to inaccurate measurements.
If you notice during training that the values which must be displayed by
the computers appear irregularly or the symbol "P" appears in the dis-
play, conduct the following check procedure:
a. Check that the strap is not too loose and/or has slipped too far dow-
nwards.
b. Check whether the Christopeit-sport Brand on the transmitter of the
pulse measuring unit is positioned correctly and is legible to a person
looking at the person in training.
c. Ensure that the computer is switched on.
d. Moisten the part of the strap neat the transmitter and which comes
into contact with the skin lightly with water to improve the transmis-
sion.
e. Check whether the battery in the transmitter is spent and change
this if necessary.
f. Remove and replace the batteries.
If you use both pulse measurements (you wear the pulse belt and put
the hands onto hand pulse sensors) the display will show the value of
hand pulse sensors.
Don't forget to press Start-key to start pulse measurement.
"WARNING" Heart rate monitoring system may be inaccurate. Over
exercise may result in injury or death. If you feel faint stop exercising
immediately.
18
GB