Troubleshooting - Christopeit Sport RPT 6200 Montage- Und Bedienungsanleitung

TROUBLESHOOTING

In case of malfunctions may adjoining list of error messages help for savvy people to get function back. Basically, electrical repairs only in
compliance with the relevant safety rules which exists. For more information and assistance in case of malfunctions with our service depart-
ment (contact details see last page.)
Problem Potential reasons
---- The safety lock is removed
E01 Communication abnormality: abnor-
mal communication between the con-
troller and the electronic meter after
powering on.
E02 Voltage-proof protection:
E03 No sensor signal:
E05 Over-current protection:
E07/ E08 EEPROM defect
Motor The motor cable is damaged or con-
startet nected incorrectly.
nicht The fuse on the control board has
been damaged or dropped.
The control board is defect.
The motor is defect.
Training area in mm
(for home trainer and user)
Solutions
1. Put the safety clip in position
2. Change the safety clip or safety clip socket at computer.
3. If it's still not ok, than change the computer.
1. Switch off the treadmill and plug out AC cable.
2. Check each section of communication cables from the electronic meter to the controller
and ensure that all cables are well connected.
3. Check whether cables between the electronic meter and the controller are damaged; if
yes, replace the damaged wire.
1. Switch off the treadmill and plug out AC cable
2. Check whether the power supply voltage is less than 50% of the normal value. Please
ensurecorrect voltage and test again.
3. Check whether the controller emits the odor of burning; if yes, replace the controller.
4. Check whether motor cables are well connected; re-connect motor wires.
1. Switch off the treadmill and plug out AC cable.
2. Check whether the sensor cable is well plugged or whether it is damaged; plug it well or
replace the sensor.
1. Check whether power supply voltage specifications is inconsistent or too low and use
correct voltage specifications for re-test.
2. System self-protection is triggered under excessive current caused by the excessive load
more than the rated value, or some place of the treadmill is jammed so that the motor
cannot rotate; thus, the system start up self-protection against excessive current under ex-
cessive load; adjust the treadmill and restart it.
3. Check whether there is over-current sound or burning odor when the motor is running;
replace the motor.
4. Check whether the controller emits abnormal odor; replace it if yes.
Replace the control board.
Check the motor cable.
Check the fuse. Reinsert it, or replace the fuse.
Replace the control board.
Replace the motor.
Free area in mm
(Training area and secu-
rity area (rotating 60cm))
19
The free area in the directions
of access to the treadmill must
have at least an area of (0.6 m +
the training area). During training,
there must be a free safety area
behind the treadmill of at least
2000 mm in length and at least
the width of the treadmill.
GB