ChiQ MG80-14586BW Benutzerhandbuch Seite 7

CONNECTION THE ELECTRICITY AND WATER
SUPPLIES
Connecting the water inlet hose
1. Connect one end of the water inlet hose to a
cold water tap and tighten by hand (see figure).
Before performing the connection, allow the
water to run freely until it is perfectly clear.
2. Connect the other end of the water inlet hose
to the water inlet valve on the rear of the
appliance and tighten by hand.
3. Turn on the tap slowly and make sure there are
no leaks.
Do not twist, squash, modify or cut the hose.
•
Tighten the end of the hose firmly by hand.
•
The supply water pressure must be in the
•
0.03—1.0MPa range. If the water pressure
•
exceeds
this value, please fit a pressure reducing
•
valve.
If the hose is not long enough, contact a
•
specialized shop or an authorized technician.
•
Never use second-hand water inlet hose.
•
Use the new water inlet hose supplied with
•
the washer.
Connecting the drain hose
Height of drain point
Height difference between the floor and drainage
point: min. 60cm(24 in.) and max. 100cm(39 in.).
Types of drainage hook-ups
■ Standpipe
Attach the drain hose to the elbow (no supplied,
available from our Customer Service
Department). Position the elbow on the drain
hose 4" from end of the hose as shown. Insert
this section of the drain hose into the drainpipe.
Secure the elbow and hose with a nylon tie strap
or the equivalent to keep the hose from coming
out of the drainpipe during use.
■ Sink siphon
Secure the drain hose to the sink siphon using a
Ǿ0.9-1.6 in.(20-44mm) hose clip (available from a
hardware store). Before connecting the drain
hose ensure that any blanks or removable ends
have been taken off the spigot.
■ Wash Basin
Make sure that:
- There is no stopper in the sink drain.
- The end of the drain hose does touch the
discharge water.
- The sink drain is free flowing and not partially
clogged.
Attach the drain hose securely to the wash basin.
Do not twist, pull out or bend the drain hose.
•
We advise against the use of hose
•
extensions; in case of absolute need, the
extension must have the same diameter as
the original hose and must not exceed
150cms in length. Ensure that if the drain
hose is pushed into a standpipe, that the end
does not go down more than 15cms (6
inches). If the hose is pushed down too far,
this may cause the washer to self-syphon i.e.
continuously empty as it is filling.
7