Daily Use; Preparing The Laundry - ChiQ MG80-14586BW Benutzerhandbuch

Before loading your first load of laundry
Your new washer was tested before leaving the factory. This process involves running various wash cycles.
As a result, a small amount of water may remain in the tub and drainage system. Run a Drum Clean cycle
with no laundry to clean the system before your first load of laundry.
First add 1 to 2 tablespoons of detergent to the chamber I. Then run the Drum Clean cycle.
Wait for the cycle to finish.

Daily Use

Preparing the laundry

EMPTY POCKETS
Coins, paper clips, etc. could damage the load and the washing machine components.
•
Tissues will break down during the wash cycle and the fragments will have to be subsequently removed
•
by hand.
CLOSE ALL ZIPPERS, BUTTONS, AND HOOKS. TIE ALL RIBBONS OR BELTS
Insert the smaller garments (e.g., nylon hosiery, belts, etc.) and garments with hooks (e.g. braziers) into
•
a fabric bag or a pillowcase with zipper. Remove any rings from curtains, or else place the curtains
inside a fabric bag together with the rings.
FABRIC TYPE/SYMBOL ON THE WASH LABEL
Cottons, mixed fibres, easy care/synthetics, wool, hand wash items.
•
Colour: Separate coloured and white items. Wash new coloured articles separate.
•
Size: Wash items of different sizes in the same wash load, to improve washing efficiency and
•
distribution of the articles in the drum.
Delicate: Wash delicate items separately; they require gentle treatment.
•
How to use the washer
1. Load laundry
Open the door and load the laundry. Load the articles one at a time loosely into the drum, without
overfilling. Observe the load sizes given in the "Table of wash cycle", Overloading the machine will result in
unsatisfactory washing results and creased laundry.
2. Close door
Make sure that no laundry gets stuck between door glass and rubber seal. Close the door so that you can
hear it click shut.
3. Open water tap
Make sure that the washing machine is connected to the water mains. Open the water tap.
4. Set the desired program
Select the required program with WASH CYCLE SELECTOR knob. The duration of the wash cycle is shown on
the display. The washing machine automatically displays the default temperature and spin speed settings
possible for the selected program. Adjust the temperature and/or spin speed setting if needed with the
relative buttons.
Change temperature, if needed
•
Press the TEMP. button to progressively lower the temperature setting until cold wash has been set (all
temperature value indicator light go out on the display). Pressing the button again sets the highest possible
setting.
Change spin speed, if needed
•
Press the SPEED button to progressively decrease the spinning speed until the spin cycle is turned off (all
spinning speed value indicator light go out on the display). Pressing the button again sets the highest
possible setting.
Select options, if needed
•
Press the button to select the option, the respective option indicator on the display illuminates.
Press the button again to cancel the option; the respective option indicator extinguishes.
- If the selected option is incompatible with the program set, the incompatibility will be signalled by a
buzzer and the corresponding indicator light will flash.
- If the selected option is incompatible with another previously set option, only the most recent selection
will remain active.
15