Various Functions - ChiQ MG80-14586BW Benutzerhandbuch

Various functions

Delay end
Press DELAY END button to set the program end (Delay end) time in one hour increments to a maximum of
24 h (hours). After selecting the desired washing program but before pressing the START/PAUSE button,
press the DELAY END button until the desired time is displayed, e.g. 8h.
NOTICE: The cycle duration is included in the set Delay End time.
Here is an example of a 1hr: 30 min cycle time and an 8 h Delay end time.
8 h is displayed and count down (approximately 6 h: 30 min) until the washing cycle begins (at 1hr: 30 min)
then the cycle duration 1: 30 is displayed and began. Total time approximately 8 hours.
The way to cancel Delay End function:
Turn the wash cycle selector knob to reset the wash cycle.
•
NOTICE:
Delay End function cannot be set some wash cycle.
•
The end time of the wash cycle may be different from the actual reservation time depending on the
•
water supply pressure, drainage, clothing type, water temperature and other conditions.
Child lock
1. Setting the Child lock function can avoid children's mis-operation and external interference to the
washing procedure.
2. During operation, long press the SPEED button for 3 seconds to set or cancel the Child lock function.
3. After the Child lock function is set, the indicator light is illuminated, the door cannot be opened, the
control panel is locked and all buttons on control panel do not respond. You can turn off the machine
by turn the wash cycle selector knob.
4. After the child lock function is set. When the machine is turned on again, the machine directly run the
program before turning off the machine.
Cancelling the buzzer
Press and hold the SPEED button and ONE TOUCH button together at the same time for at least 3 seconds,
you can turn off the buzzer that sounds during the washing cycle running.
To activate the buzzer setting
•
Do the same operation as you did for cancelling. The buzzer setting is activated after one beep.
Add clothes during the program is running.
When the program is running, long press the START/PAUSE
and add clothes. After the operation is completed, close the door, long press the START/PAUSE
again, and the machine continues to run.
NOTICE: If the water level or water temperature in the drum is too high, the door lock indicator light is
illuminated, the door cannot be opened and the midway clothes filling function cannot be used.
DIY time
Adjust the program time by pressing the DIY TIME button. The program time adjustment value is
•
displayed on the digital display screen, and the washer will run according to the adjusted program time.
Some programs cannot select DIY time function.
•
Load balancing system
The washer has an automatic detection system for eccentric load. In the process of spinning, if the clothes
are unevenly distributed, the washer will level and adjust the clothes until the clothes are evenly distributed
before spinning. If the clothes cannot be evenly distributed within the specified time, the washer will not
spin to avoid severe vibration of the machine. At this time, you need to check whether the clothes are
knotted or entangled and select the "Spin" program after reorganizing the clothes. When washing less
clothes, such as a pair of jeans, a sweater, a bath towel, etc., the machine may not complete the spinning
process due to balance protection. Please wash the large and small clothes together as much as possible to
make the clothes easier to release evenly and complete the spinning process smoothly.
NOTICE: Due to the different types and materials of the laundry, the automatic adjustment and balance
system of the washer may level and adjust the clothes for many times to prolong the spinning time. This is a
normal phenomenon, not a machine failure.
button to pause the machine, open the door
14
button