Herunterladen Inhalt Inhalt Diese Seite drucken

ChiQ MG80-14586BW Benutzerhandbuch Seite 20

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 86
The machine wont spin
properly
The machine leaks from
the dispenser
The machine leaks
(other than dispenser)
The machine smells
The machine door
cannot be opened.
The water level is too
low when the machine
is washing
There is too much foam
General
Out of Balance detected when attempting to go into a spin cycle – If this
happens the washer will continue to try to repeat the distribution of the load
required before the machine will go into higher spin speeds – This will
increase the program time accordingly. This is a safety feature to prevent
damage. Out of Balance can be caused by washing a single heavy item (e.g.,
down, quilt, etc). – Try the programme again using a different load.
The dispenser drawer is blocked with detergent and requires cleaning.
The water pressure is too high and requires turning down – turn down the
tap on the water supply pipe slightly and try again.
The washer is tilting forwards – It must be level when in its final position.
The inlet hose is loose, check both the cabinet and tap ends .
The inlet hose is tight but still leaks, if so replace the rubber washers, or the
inlet hose is missing the rubber washer.
The drain hose is not fixed in properly.
The washer requires a service wash. Run a "Drum Clean" wash cycle with
detergent and no laundry.
The door will not open until the door lock indicator light goes out shortly
after the program has finished.
If there is no power to the machine you need to perform the manual
unlocking procedure.
The water level is correct if it can be seen at the bottom of the door
The detergent is not suitable for machine washing (it should display the text
"for washing machines" or "hand and machine wash" or the like).
Too much detergent was used – less detergent is required in soft water.
Your washer contains sensors that monitor progress during the wash cycle
(e.g.: Water level, Temperature, Out of balance loads, Wash time/progress).
Normally, if your washer successfully completes the cycle, there is unlikely to
be anything wrong!
20

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Mg100-14586bx

Inhaltsverzeichnis