ChiQ MG80-14586BW Benutzerhandbuch Seite 16

5. Add detergent
Pull out the detergent dispenser and add detergent (and additives/softener) into the relative compartments
as described below.
Compartment 1:
Powder washing detergent
Compartment 2:
Liquid washing detergent
The liquid detergent must not exceed the "MAX" level.
Compartment 3:
Additives (Softener. etc.) The fabric softener must not exceed the "MAX" level.
Observe the dosing recommendations on the detergent pack.
Correct dosing of detergent/additives is important, because:
It optimizes the cleaning result.
•
It avoids irritating residues of surplus detergent in your laundry.
•
It saves money by avoiding waste of surplus detergent.
•
It protects the washer by avoiding calcification of components.
•
It respects the environment by avoiding unnecessary environmental burden.
•
! Do not use hand washing detergents because these create too much foam.
! Use powder detergent for white cotton garments, for pre-washing, and for washing at temperatures
over 60℃.
! Follow the instructions given on the detergent packing.
6. Delaying the end of a program
To set a program to end at a later time, see the section "Control panel / DELAY END".
7. Start program
Press the START/PAUSE button. The relative indicator lamp illuminates, the door locks and the DOOR LOCK
indicator lights up.
To avoid overflow, do not open the detergent dispenser during a running program anymore.
•
The remaining program duration can vary. Factors like unbalance in the wash load, or foam formation,
•
can influence the program duration.
8. Change the settings of a running program, if needed
You can still change the settings while a program is running. The changes will be applied, provided the
respective program phase has no finished yet. To change the settings of a running program:
Press START/PAUSE button put the running program on pause.
•
Change your settings.
•
Press START/PAUSE button again to continue the program.
•
If you have changed the program, do not add detergent for the new program.
To prevent that a running program is changed by accident (for instance by children), use the Child lock
function (see section "Control panel / SPEED").
Pause a running program and open the door, if needed
Press START/PAUSE button to pause a running program.
Provided water level or temperature is not too high, the DOOR LOCK indicator light turns off. You can open
the door, for example to add more laundry, or to remove laundry which was loaded by mistake. Press
START/PAUSE button again to proceed with the program.
9. Cancelling a running program, if needed
Turn the wash cycle selector knob to OFF position until the washer stops.
•
If the water level and temperature are low enough, the door unlocks may be opened.
•
The door remains locked if there is water in the drum. To unlock the door, switch the washer on, select
•
the Spin program and turn the spin option off by pressing the SPEED button to set the spin cycle is
turned off (all spinning speed value indicator light go out on the display).
Press START/PAUSE button to running Spin program. The water is emptied, and the door unlocks at the
•
end of the program.
10. Switch off the washer after program End
At the end of the cycle, the message "End" is shown on the display.
•
The door can only be opened when the symbol DOOR LOCK indicator turns off.
•
16