Setting Mode; How To Navigate In Setting Mode - Electrolux GA60SLVS Benutzerinformation

14 www.electrolux.com

7.1 Setting mode

How to navigate in setting
mode
You can navigate in setting mode using
MY TIME selection bar.
A. Previous button
B. OK button
C. Next button
Use Previous and Next to switch
between the basic settings and to
change their value.
Use OK to enter the selected setting and
to confirm changing its value.
How to enter setting mode
You can enter setting mode before
starting a programme. You cannot enter
setting mode while the programme is
running.
To enter setting mode, press and hold
simultaneously
about 3 seconds.
• The lights related to the
Previous, OK and Next are on.
• The display shows the first
available setting and its current
value.
Water hardness
German de‐
grees (°dH)
47 - 50
43 - 46
37 - 42
29 - 36
A B C
and
French de‐
grees (°fH)
84 - 90
76 - 83
65 - 75
51 - 64
How to change a setting
Make sure the appliance is in setting
mode.
1. Use Previous or Next to select the
desired setting.
The display shows the setting name and
its current value.
2. Press OK to enter the setting.
The display shows available values.
3. Press Previous or Next to change
the value.
4. Press OK to confirm the setting.
• The new setting is saved.
• The appliance returns to the basic
5. Press and hold simultaneously
seconds to exit setting mode.
The appliance returns to the programme
selection.
The saved settings remain valid until you
change them again.
7.2 The water softener
The water softener removes minerals
from the water supply, which would have
a negative effect on the washing results
and on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness
is measured in equivalent scales.
The water softener should be adjusted
for
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water
in your area. Set the right level of the
water softener to assure good washing
results.
mmol/l mg/l (ppm)
8.4 - 9.0 835 - 904
7.6 - 8.3 755 - 834
6.5 - 7.5 645 - 754
5.1 - 6.4 505 - 644
settings list.
and for about 3
Clarke Water soften‐
degrees
58 - 63
53 - 57
46 - 52
36 - 45
er level
10
9
8
7