Connect The Camera On An Adsl Network - Velleman CAMIP7N Bedienungsanleitung

12. Additional information
12.1 Password
The default administrator login is admin without a password. To
enhance security, a new administrator password should be set as
soon as possible (see above).
If you have lost the administrator password, you can reset the
camera to factory defaults (admin, no password) by pressing and
holding the RESET button at the bottom of the camera for about 5
seconds.
When doings so, all other user settings will be lost as well.
12.2 WiFi
1. Refer to the user manual of your wireless router to obtain
network information e.g. SSID, Channel, Security,
authentication, encryption...
2. Use previously obtained information to configure your camera
via a fixed network cable
(see Wireless LAN settings).
3. Reboot the camera.
4. Wait at least 30 seconds before unplugging the network cable.
Then unplug the power supply.
5. Re-insert the power plug.
After about 30 seconds, the camera should be up and running in
WiFi mode.
12.3

Connect the camera on an ADSL network

1. Connect the camera to a PC. The easiest way is to use a router.
If no router is available, you must use a cross cable (not incl.) to
connect the camera directly to the PC's network port (RJ45) and
set the IP addresses on PC and camera manually.
2. Configure the camera with the IP camera tool (see above).
3. Log on to the camera as administrator and configure ADSL
settings (user name + password).
4. Configure the DDNS Service Settings and click Submit. The
camera reboots.
5. Connect the camera directly to the ADSL modem. It is now
available through the internet by entering the domain name in
your internet browser.
V. 08 – 04/06/2015
CAMIP7N
26 ©Velleman nv