Velleman CAMIP7N Bedienungsanleitung Seite 28

 If the camera is behind a firewall, make sure the firewall software
is allowing inbound connections on port 80. If not, use an
alternate port. The same goes for certain anti-spam and anti-virus
software packages.
 If the camera is behind a cable/DSL router, make sure to
configure port forwarding properly. Refer to the user manual of
the router.
No image
 Video streaming is transmitted by the ActiveX controller. If this
controller is not installed properly, no video image is shown.
 When you install the IP Camera Tool, the ActiveX controller is
installed at the same time. If not, download the ActiveX controller
from the internet and set the safety properties of your web
browser so it accepts ActiveX content.
Slow image
The frame rate of the shown video depends on a number of external
factors, e.g.:
 Network bandwidth
 PC performance and display settings
 Number of visitors that are viewing the camera simultaneously
 Network equipment (e.g. use a switch instead of a hub for
multiple IP cameras).
Camera not available via internet
Possible reasons may include:
 ActiveX controller is not installed or not working properly.
 The port of the IP camera is blocked by a firewall or anti-virus
software. In this case, try using a different port number.
 Port mapping failed. Either enable UPnP (via UPnP Settings) or
edit the routers Virtual map list (refer to the user manual of your
router).
14. Technical specifications
pick-up element
lens
lens angle
min. illumination
number of pixels
V. 08 – 04/06/2015
CAMIP7N
1/5" colour CMOS sensor
f2.8mm / F2.4
60°
0.5 lux
640 (H) x 480 (V) - PAL -
28 ©Velleman nv