Herunterladen Inhalt Inhalt Diese Seite drucken

Network Setup; Installation: Hardware - Velleman CAMIP12N Bedienungsanleitung

Megapixel ir video dome ip-kamera - eagle eyes - ets
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

4.2

Network setup

5.

Installation: hardware

You can install the camera as follows:
1. Separate the dome cover from the camera.
2. Make sure the screw holes on the plate are aligned with the holes on the camera base.
If not, slightly loosen the two screws on the plate and rotate it.
3. Mark the locations of the two screw holes on the ceiling, and drill a hole for each on the ceiling.
The distance between your camera and the location you want to monitor should be 3 ~ 4 meters.
4. Fix the camera to the ceiling with the supplied screws.
5. Adjust the position and viewing angle of the camera, and fasten the two screws on the plate to fix.
6. Replace the dome cover back to the camera.
1
V. 01 – 11/08/2014
CAMIP12N
8
9
3
2
3
Reset button
microSD card slot
1
Mobile device
2
LAN port
3
Wireless router
4
WAN port
5
Modem
6
Network cable (RJ45)
7
CAMIP12N
1
Loosen to remove dome cover
2
Loosen slightly to rotate plate
3
Screw hole
©Velleman nv

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis