Herunterladen Inhalt Inhalt Diese Seite drucken

Blo Ing In Confined Spaces - Makita DAS180 Betriebsanleitung

Akku gebläse
Vorschau ausblenden Andere Handbücher für DAS180:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 38

Blo ing in confined spaces

Recommended nozzles
Nozzle 3
Blow into confined spots, corners, and spaces by the
walls to dust o .
P o i n t t h e n o z z l e s t r a i g h t a t s p a c e s a t a r e a s o n a b l e
d i s t a n c e a n d s q u e e z e t h e s w i t c h t r i g g e r t o c o n t r o l b l o w -
i n g a i r v o l u m e .
Fig.26
Fig.27
CAUTION:
Keep the nozzle a ay a reasonable
distance from blo ing spots to avoid blo ing up
dust into the air.
CAUTION:
Use personal protective e uip-
ment such as a dust mask and eye protection.
NOTICE:
Avoid blocking the air vent holes
around the blo er outlet. I t o t h e r w i s e m a y c a u s e
sudden noise and vibrations and could possibly a ect
t h e t o o l p e r f o r m a n c e .
Fig.2 :
. A i r v e n t h o l e s 2. B l o w e r o u t l e t
Dusting air filter
Recommended nozzles
Nozzle 7
Dust filter surfaces by blowing air through one side of
the filter to the other.
Direct the nozzle on filter surfaces within a short dis-
t a n c e a n d s w i n g i t f r o m
f r o m
s u r f a c e s .
Fig.2
CAUTION:
Use personal protective e uip-
ment such as a dust mask and eye protection.
NOTE: P o i n t t h e n o z z l e a t a n a n g l e a c c o r d i n g t o t h e
outlines of the filter so the adhered dust can be easily
r e m o v e d .
Blo ing ide and open area
Recommended nozzles
Wide range nozzle
B l o w a i r o v e r d i r t a n d l i q u i d o n w i d e - o p e n s u r f a c e s s u c h
as desktop and floor, using the five-hole nozzle with 1
d e g r e e r a n g e o f b l o w i n g .
D i r e c t t h e n o z z l e o v e r a l a r g e a r e a w i t h i n a c e r t a i n
d i s t a n c e a n d s w i n g i t b a c k a n d f o r t h a n d f r o m
s i d e t o b l o w w i d e l y .
Fig.30
CAUTION:
Use personal protective e uip-
ment such as a dust mask and eye protection.
s i d e t o s i d e t o b l o w d u s t a w a y
s i d e t o
Inflating plastic inflatables
Recommended nozzles
Pinch valve nozzle
Nozzle 13
Inflatable air volume ith fully charged battery
cartridge BL
60B ithout recharging it
Air volume mode
4: M a x
3 : H i g h
2: M e d i u m
1: L o w
NOTE: T h e m a x i m u m o u t p u t a i r p r e s s u r e o f t h i s t o o l i s 20.2 k P a .
( W i t h n o z z l e 1 3 )
Inflate beach toys, pillows, and similar small plastic
inflatables with pinch valve nozzle.
Inflate garden pools, air mattresses, and similar large
plastic inflatables with nozzle 1 .
Insert the nozzle into an air inlet on an inflatable item
and pull the switch trigger to start inflating.
Slowly release the switch trigger to reduce air volume as the inflat-
able item comes close to fully inflated. Remove the nozzle from
the air inlet after stopping the air flow and then close the air inlet.
Fig.3
Fig.32
CAUTION:
Al ays be careful not to over-in-
flate inflatables during operation. I t o t h e r w i s e m a y
burst the inflatables, possibly causing damage to the
tool and personal injury.
CAUTION:
Never leave the tool unattended
hile the nozzle is attached to inflatables or
during operation.
CAUTION:
Be a are that heated air stream
may flo through the air vent hole at bottleneck
of the pinch valve nozzle due to air circulation.
NOTE: M a k e s u r e t o i n s e r t t h e p i n c h v a l v e n o z z l e
f u l l y t h r o u g h t h e a i r i n l e t s o t h e n o z z l e h e a d s e r v e s t o
open the flap valve inside the air inlet.
NOTE: For an inflatable item with a small air inlet
o p e n i n g , i n s e r t t h e n a r r o w t i p o f t h e p i n c h v a l v e n o z -
z l e i n t h e a i r i n l e t u n t i l t h e b o t t l e n e c k o f t h e n o z z l e
h e a d t o u c h e s t h e r i m
NOTE: For an inflatable item with a large air inlet
o p e n i n g , i n s e r t t h e p i n c h v a l v e n o z z l e h e a d f u l l y i n t o
the air inlet to open the flap valve inside the air inlet.
Fig.33:
. F l a p v a l v e 2. S m a l l a i r i n l e t o p e n i n g 3. L a r g e
a i r i n l e t o p e n i n g 4. B o t t l e n e c k
NOTE: If an air inlet on an inflatable item is relatively
s m a l l e r t h a n t h e p i n c h v a l v e n o z z l e h e a d , s q u e e z e
a n d e n l a r g e t h e a i r i n l e t b y h a n d a n d t h e n t w i s t a n d
h o l d t h e n o z z l e h e a d i n t o t h e a i r i n l e t .
19 ENGLISH
Number of ø6 cm
Inflatable air
plastic beach balls
volume
e uivalent in air
With pinch valve
volume
nozzle
With pinch valve
nozzle
3
13 .0 m
110
3
13 .4 m
115
3
15.6 m
13 0
3
22.8 m
19 0
o f t h e a i r i n l e t .
. A i r v e n t h o l e

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis