CONSTRUCTA CD33686 Gebrauchs- Und Montageanleitung Seite 32

en Installation instructions
10. Note:
Cabinets that hang freely on the wall or only adhere
to one side of another cabinet must be stabilised
using additional screws. If your cabinet is supported
by additional cabinets from both sides, you can skip
this step.
To stabilise the cabinet walls, screw in the screws
on the right and left using a screwdriver.
Insert the mains plug.
11.
Remove the protective film from the grease filters
12.
and insert the grease filters into the appliance.
Refit the cabinet door.
13.
14. Note: Ensure that the safety mat does not protrude
over the front of the appliance.
Measure the flat surface and trim the safety mats to
size.
Insert the safety mats.
15.
Removing the appliance
Unplug the mains plug.
1.
Detach the cabinet door.
2.
Remove the grease filters.
3.
If the cabinet walls have been stabilised with 2
4.
wooden screws, unscrew both screws.
32
Note: Before removing the appliance, remove any
5.
objects from the shelf.
Carefully remove the covers.
Open the glass panel and unscrew the threaded
6.
pins in the rail.
Remove the safety mats on both sides.
7.
Push in the two locking points at the side
8.
carefully remove the duct
Loosen the pipework.
9.
Close the glass panel
10.
​ ⁠ .
​ ⁠ and
​ ⁠ .
​ ⁠ and remove the appliance