Cleaning And Maintenance - cecotec Cumbia POWER MATIC-CCINO 6000-Serie BIANCA Bedienungsanleitung

ENGLISH
Remove the water tank from the coffee machine and fill it with fresh water again.
The machine will start the rinsing cycle.
Note: The water tank is suitable and compatible with the Cecotec Matic-ccino filter, which
guarantees properly filtered water for a better maintenance, a longer service life of the coffee
maker and better coffee flavour. For perfect results, we suggest you change the filter regularly,
at least every 2 months, for full effectiveness.
Fig. 11
Temperature setting
From the temperature menu, use the up and down buttons to increase or decrease the
temperature of coffee extraction. These temperature settings are: 75, 80, 85, 90 and 95 Celsius
degrees.
Fig. 12
Auto-off
From this menu, use the up and down buttons to set the time you want the machine to stay on
before switching to standby mode (0.5 hrs, 1 h, 1.5 hrs... up to 24 hrs).
Fig. 13
Factory settings
To restore the coffee maker's factory settings, once you have entered this 3rd menu, press the
espresso button.
Fig. 14
Coffee machine data
The last menu will display data related to the coffee machine, such as manufacturing date and
serial number.
Fig. 15

4. CLEANING AND MAINTENANCE

Disconnect the power cord from the wall socket before cleaning. Do not immerse the product
in water or any other fluid during cleaning.
Allow the coffee machine to completely cool down. Be careful not to burn yourself!
Use a soft, dampened cloth to clean the outer part of the device.
Failure to maintain the product in clean conditions could lead to surface deterioration and
could adversely affect the product's shelf life, resulting in possible hazard.
It is suggested to descale the device every 2 or 3 months.
Never use strong detergents, abrasive powder or metal brush to clean any part of the product.
42
Store the machine in a safe, dry and clean place if it is not going to be used during long periods.
Clean both the visible parts of the machine and the area beneath it in order to remove all
residues.
Thoroughly clean and empty the tank before storing the device.
Clean the steam exit with a wet sponge immediately after use. Be careful not to burn yourself!
Then, remove the steam tube and clean the duct's inside part. It is also recommended to run
the steam function again to remove possible remaining blockages.
Help yourself with the cleaning brush to periodically clean the ground coffee tube and to clean
remaining residues stuck to the walls which could be blocking ground coffee in the grinder.
Note: The drip tray, the coffee residues tank and the water tank are dishwasher safe.
Cleaning the brewing unit
Open the right-side door.
Remove the coffee residues tank and rinse it with hot water.
Remove the brewing unit and rinse it with hot water too. Make sure to clean all the remaining
coffee rests with the cleaning brush.
Insert the brewing unit back in its position. You will listen a "Click" when it is properly fixed in
its correct position.
Reassemble the coffee residues tank in its position.
Fig. 16
5. TROUBLESHOOTING
Warning signal and solution:
Fill the water tank. (1)
Add coffee beans to the tank. (2)
Drip tray error. Please, install it in its correct position. (3)
Fig. 17
The coffee residues tank is not installed in place or full. Please, empty it and install it in its
correct position. (4)
The brewing unit is not installed in place. Please, install it in its correct position. (5)
The right door is open. Please, close it. (6)
Fig. 18
Water tank error. Please, push the water tank into the correct position. (7)
The coffee machine is turning on, please wait. (8)
Fig. 19
For any further doubt or question, contact the official Technical Support Service of Cecotec.
ENGLISH
POWER MATIC-CCINO 6000 SERIE BIANCA / NERA 43