Technical Data - HANSGROHE Talis S 32852 Serie Montageanleitung

Important! The fitting must be installed, flushed and
tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in posi-
tion on the sink.
Hole Ø 36 mm!
3. Slip the plastic washer, the slide washer, the metall
washer and collar over the hoses and threaded
base and tighten the collar nut by hand. If there is
not enough space, please use only the slide washer
and the metal washer without the plastic washer.
4. Tighten screws.
5. Connect the back flow preventor cartridge to the
angle valve. Connect the connecting hose to the
back flow preventor cartridge.(see page 4)
Operation
By turning the handle on the left hand side the thermostatic
mixer is opened, closed and the flow can be changed from
tub to shower function.
The temperature is selected by turning the graduated
handle on the right side.
Fault
Insufficient water
Mixer stiff
Mixer dripping constantly with water
heater switched off
Water escaping in area of swivel
spout
Water escaping at the threaded
base
Water escaping bels ow handle
English
Important!
With water heaters of 5 liters the flow rate at the mixer
should not exceed 5 l/min.
In this case the flow rate must be reduced at the isolation
valve.
When the storage tank is being heated, the spout will
drip.
When changing the spray former, it is imperative to use
one made for this type of mixer.

Technical Data

Operating pressure:
Recommended operating pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Rate of flow:
Maintenance non return valve
The non return valves must be checked regularly according
to DIN EN 1717 in accordance with national or regional
regulations (at least once a year).
Spare parts (see page 3)
Cause
- Spray former calcified, dirty
- Cartridge defective, calcified
- Cartridge defective
- O-ring defective
- connection hoses not completely
screwed into basic body
- O-ring at the connection hose
defective.
- Cartridge defective
max. 1 MPa
0,1 - 0,5 MPa
max. 80° C
65° C
max. 5 l/min
Remedy
- Clean spray former, exchanging if
necessary
- Exchange cartridge
- Exchange cartridge
- Exchange O-ring
- Tighten connection hoses by hand
- Exchange O-ring
- Exchange cartridge