Cleaning And Replacement; General Maintenance - Swim & Fun 1932 Bedienungsanleitung

6. The filter pump must be positioned on level, stable ground.
7. To preserve the full life of the pump and to keep the pool filtered properly, your
pump should be run approximately 4 to 6 hours per day.
8. Overuse may cause overheating and/or motor burnout. Use good judgment on
extremely days and be mindful of running the filter pump continuously for an extended
period of time.
5.

Cleaning and replacement

1. The Swim & Fun Filterballs in your pump filter system should be replaced approxi-
mately once per season.
2. Periodically cleaning of your Swim & Fun Filterballs can enhance the effectiveness
of your filter pump and moderately prolong the Swim & Fun Filterballs lifespan prior to
replacement.
3. Keep the power be disconnecting to the unit when changing the Swim & Fun
Filterballs.
4. Turn the air vale screw to release the air suction inside.
5. Remove the filter lid and the filter chamber rubber gasket, and then take out the
Swim & Fun Filterballs.
6. Your clean (or new) Swim & Fun Filterballs can be put back into the filter chamber
and you can refer to the installation instruction to re-assemble the filter pump unit.
6.

General maintenance

1. To avoid dangerous or fatal electrical shock hazard, always disconnect power to the
unit before attempting to clean pump.
2. There is no need for any regular mechanical maintenance of the pump unit.
(Do not attempt to disassemble the pump motor at any time).
3. If necessary, clean outside of pump with a mild detergent and water, rinsing off with
a hose.
4. There is no need for the use of any lubricants on the pump.
MV-1932-04-2022 swim-fun.com © Alle rettigheder forbeholdes Swim & Fun A/S
UK
37