Cleaning The Bottom Of The Pool; User Instructions For The 7-Way Valve - Swim & Fun Classic 300 Bedienungsanleitung

GB
7.

Cleaning the bottom of the pool

Switch the pump off. Use a hose clamp to connect a pool hose to the round suction plate of the
pool skimmer. Alternatively place a pool hose into the bottom of the skimmer. This will demand a
sucking hose with a special muff connector. Make sure all air comes is out of the hose before clea-
ning. Fill the hose with water by holding it in front of the inlet to the pool while the pump is running.
The air will hereby come out. The hoses can be air free under water using a weight load. That
could be a weighted vacuum cleaner mounted on a telescopic pole.
Set the lever on FILTER. Switch the pump on and brush the bottom and the walls. Make sure no
air enters as it could defuse the pump or cause damage to it by making it work without water.
When cleaning is finished, stop the pump, turn the lever to BACKWASH, switch the pump on and
wash for one minute to eliminate dirt. Switch the pump off, set the lever on RINSE and switch the
pump on for half a minute for a light rinse. Cleaning operations are now finished.
8.

User instructions for the 7-way valve

The filter system has a 7-way handle on top of the tank, wherefrom you can manually manage the
cleaning process. Press the handle down and rotate it to the desired position. Following positions
are available:
FILTER:
BACKWASH:
CIRKULATION:
RINSE:
DRAIN:
CLOSED:
WINTERIZE:
Beware!
NEVER use the valve lever as a handle to carry or lift the filter. It is not made for that
use. The handle will simply break off.
MV-1030-1050-03-2019 . © All rights reserved Swim & Fun Scandinavia ApS
The dirty water comes from the pool and gets pressed down through the filter
tank and gets filtered and pumped back into the pool.
The water comes from the pool and gets pushed op through the filter tank and
pumped away to a drain.
The water runs from the pool and returns again without getting filtered.
The water comes from the pool and the top valve is cleaned from sand grains.
This should be done after a backwash procedure.
The water comes from the pool and is pumped directly out of the pool without
filtration. Water can be lead to a drain.
All positions are closed. The water cannot circulate. This position is used when
the filter is connected to the pool, but not in use.
This position is used during winter. Be sure that the filter and pump is
100% emptied from water and demounted the pool. Place the system frost free
during winter. (This position also relieves the gasket and sealing in the valve).
Side 39