Safety Warnings; Installation Instructions - Swim & Fun 1932 Bedienungsanleitung

2.

Safety warnings

The following important points should be read and under stood prior to use:
1 . The maximum head of the pump is 3.7m (for pumps having rated power input ex-
ceeding 100W). Maximum liquid temperature: 35 °C.
2. Make sure the pump be fixed before using each time with the screws.
3. This appliance can be used by children aged from 8 years and above and persons
with reduced physical, only sensory or mental capabilities or lack of experience and knowl-
edge if they have been given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved.
4. Children shall not play with the appliance. Cleaning and user maintenance shall not
be made by children without supervision. The supply cord cannot be replaced. If the cord
is damaged the appliance should be scrapped.
5. The pump must not be used when people are in the water. The supply cord cannot
be replaced. If the cord is damaged the appliance should be scrapped.
6. WARNING The pump is to be supplied by an isolating transformer of supplied
through a residual current device (RCD) with a rated residual operating current not
exceeding 30mA.
7. WARNING To prevent possible electric shock, do not attempt to plug in power cord
with wet hands while standing in water.
8. WARNING Make certain before each use of pump that all clamps are tightened and
that all hoses are connected properly.
9. WARNING Do not use this filter pump to vacuum pool.
10. WARNING Never 230 V power adapter near a swimming pool. Transformers and
power outlet should be 3.5 meters or more away from the pool. Filter pump and power
adapter may not be installed in flooded areas (where no suitable power outlet).
3.

Installation instructions

1. Set up your pool exactly. Fill it completely with water.
2. Position the filter pump unit at least 20 cm below the highest water level
in the pool.
3. And keep the filter pump at least 60 cm away from the sidewall of the pool.
4. Place Swim & Fun Filterballs and bottom sponge into the body of the filter pump.
5. Make certain that the filter chamber rubber gasket is placed in the seal groove on
the top of the filter pump.
6. Screw on filter chamber cover onto top of the body of filter pump by hand.
7. Connect the hoses same as the Installation iIIustration, fixture the pump to the wall
of pool. Remember to use hoseclamp, tighten it with screwdriver.
MV-1932-04-2022 swim-fun.com © Alle rettigheder forbeholdes Swim & Fun A/S
UK
35