SE
9.
Anslut elsladden till ett jordat uttag som skyddas av en jordfelsbrytare (GFCI). Kon-
takta en behörig elektriker för verifieringsändamål och/eller installation av ett jordat elut-
tag om det behövs.
Please install your filter pump following the lnstallation illustration bellow.
PLASTIC
CLAMP
OUTLET
OPERATING INSTRUCTIONS
1. The filter pump will prime itself as long as it is positioned at least 20 cm below the highest water
level is a relief valve located on the top of the pump. Simply turn the valve knob counter-clockwise, and
when a small amount of water escapes, close immediately by turning clockwise.
The pump will now be completely primed.
OBS!
2. Never operate the filter pump dry. This can cause damage to seals which may result in leakage and/
or flooding.
Poolen måste vara fylld med vatten upp till mitten på bräddavloppet. Vattnet måste
3. Prior to each use, check to ensure that all hose-clamps are tightened.
cirkulera till pumpen. (Se till att tanken placeras under vattenytan så att vattnet
4. To prevent possible electric shock, do not attempt to plug in electrical power cord with wet hand or
kan flöda naturligt i slangen mot pumpen.)
while standing in water.
5. The filter pump must operate in the upright, vertical position.
6. The filter pump must be positioned on level, table ground. And the use of a riser or elevated platform
is not expected.
7. To preserve the full life of the pump and to keep the pool filtered properly, your pump should be run
approximately 4 to 6 hours per day.
8. Overuse may cause overheating and/or motor burnout. Use good judgment on extremely days and be
4.
Bruksanvisning
mindful of running the filter pump continuously for an extended period of time.
1.
Filterpumpen kommer att prima sig själv så länge den är placerad minst 20 cm under
CLEANING AND REPLACEMENT
den högsta vattennivån. En övertrycksventil sitter överst på pumpen. Vrid bara ventilvre-
1. The Aqualoon in your pump filter system should be replaced approximately once per season.
det moturs och när en liten mängd vatten läcker ut stänger du omedelbart genom att
2. Periodically cleaning of your Aqualoon can enhance the effectiveness of your filter pump and
moderately prolong the Aqualoon's lifespan prior to replacement.
vrida medurs.
3. Keep the power be disconnecting to the unit when changing the Aqualoon.
Pumpen primas nu fullständigt.
4. Turn the Air Vale Screw to release the air suction inside.
5. Remove the Filter Chamber Cover and the filter chamber rubber gasket, and then take out the
2.
Använd aldrig filterpumpen torr. Detta kan orsaka skador på tätningar, vilket kan leda
Aqualoon.
till läckage och/eller översvämning.
6. Your clean (or new) Aqualoon can be put back into the filter chamber and you can refer to the
installation instruction to re-assemble the filter pump unit.
3.
Kontrollera att alla slangklämmor är åtdragna före varje användning.
GENERAL MAINTENANCE
4.
Förhindra eventuella elektriska stötar genom att inte koppla in elsladden med våta
1. To avoid dangerous or fatal electrical shock hazard, always disconnect power to the unit before
händer eller när du står i vattnet.
attempting to clean pump.
2. There is no need for any regular mechanical maintenance of the pump unit. (Do not attempt to
5.
Filterpumpen måste stå i upprätt, vertikalt läge när den är i drift.
disassemble the pump motor at any time).
3. If necessary, clean outside of pump with a mild detergent and water, rinsing off with a hose.
6.
Filterpumpen måste placeras på plan, stabil mark.
4. There is no need for the use of any lubricants on the pump.
12
CONNECTING
WATER
DIRECTION
PLASTIC
CLAMP
INLET
MV-1932-04-2022 swim-fun.com © Alle rettigheder forbeholdes Swim & Fun A/S
LOWER HOSE
CONNECTION
HOSE
WATER
DIRECTION
UPPER
PROTRUDING
HOSE
CONNECTION
WATER
DIRECTION