Maintenance - Husqvarna HA200 Bedienungsanweisung

4. Tilt the cutting unit to the applicable position.
5. Adjust the screw to set the friction.
6. Set the cutting unit in different positions to try the
friction.
To disassemble the product for
transport
WARNING:
when the product is in transport position.
1. Push the stop switch to stop the product.
2. Install the transport guard on the cutting attachment.
3. Turn the knob (A) to loosen the coupling.
A
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
24
Do not start the product

Maintenance

4. Push and hold the button (B).
B
5. Pull the cutting attachment (C) straight out of the
coupling.
6. Make sure that the cutting attachment and the
product can not move during transportation.
To set the product in transport position
WARNING:
when the product is in transport position.
1. Push the stop switch to stop the product.
2. Install the transport guard on the cutting unit.
3. Pull down the position adjustment handle.
4. Fold the cutting unit to make it parallel to the shaft.
C
Do not start the product
1183 - 002 - 16.01.2023