Husqvarna HA200 Bedienungsanweisung Seite 25

To perform maintenance on the
attachment
To do daily maintenance
A
1. Examine that the blades (A) do not move when the
throttle/power trigger is released or when the choke
is in the start position.
2. Examine that the hand guard (B) (applicable for
HA200 with gasoline powered units) is not damaged.
Replace the guard if necessary.
To do general maintenance
To lubricate the bevel gear and
gearbox
WARNING:
the product become cool before you touch
the bevel gear and gearbox.
Note:
New products are first filled with grease after
approximately 20 hours of operation.
• Use special grease. Speak to your servicing dealer
for more information.
• Add the grease through the grease nipple.
CAUTION:
1183 - 002 - 16.01.2023
B
To prevent burn injuries, let
Do not fill the gearbox fully.
To clean and lubricate the blades
1. Clean the blades from unwanted materials before
and after you use the product.
2. Lubricate the blades before long periods of storage.
Note:
Speak to your servicing dealer for more
information about recommended cleaning agents and
lubricants.
To examine the blades
1. Remove the screw from the gearbox.
2. Put the combination wrench in the gearbox and turn
clockwise and counterclockwise. Make sure that the
blades move freely.
3. Examine the edges of the blades for damages and
deformation.
4. Use a file to remove burrs on the blades.
5. Install in the opposite sequence.
25