Start Up - KitchenAid Vertigo Einbau Serie Installationsanleitung

6.5 Start up

> To start the appliance, connect the plug to the
electrical mains: at this point, when opening the
door, the control panel will usually visualize the
message "Stand by", and all the panel keys be off
>To turn on all the appliance compartments,
press the Unit button for three seconds. The
display will show the message "Initial test" for
approx. 2 minutes. After this phase the compres-
sors will start up and remain on until the default
temperature set up in the factory is reached. Do
bear in mind that this condition could last seve-
ral hours. If the appliance is provided with an Ice
Maker, prior to switching it on make sure that
the water filter cartridge is installed, then fill the
water system. To this purpose switch off the Ice
Makerand performe a manual clean procedure.
At the end switch the Ice Maker on again by tou-
ching the button.
00 Funzioni
+ °C
00
+ °C
Impostazioni
00
- °C
> For further information about the appliance
Testo e gra ca
operation, refer to the User Manual.
If at the first start - up the message Stand
Limite per gra ca parti retro-illuminate - la parte bianca è trasparente
by does not appear, but other messages ap-
pear, such as Fridge too warm, Fresco too
warm, Freezer too warm, or sound signals
are activated, it means that the appliance
has already started the cooling process.
If this is the case, deactivate any possible
acoustic signals by pressing the Alarm but-
ton, close the door and wait until the set
temperature is reached.
It is necessary to let the unit reach the correct
temperature before foods are stored inside.
BISELLATURA SUI 4 LATI BISELLATURA SUI 4 LATI
cambiamento dimensioni foro
56x43mm 29-05-2019
lati obliqui 30-03-2020
icone ridotte 29-05-2019
EN
27