Levelling; Panels Mounting; Decorative Door And Bottom-Drawer Panels Layout - KitchenAid Vertigo Einbau Serie Installationsanleitung

2

3.4 Levelling

Adjust the appliance level by means of the front
levelling feet and the rear adjustable wheels.
2
1
Operate as follows:
> After removing the bottom plinth or grille (it is
kept in position by magnets), adjust the height of
the levelling feet [ 1 ] by means of a 17 mm (3/4")
open spanner.
> Then adjust the height of the rear wheels by
turning the front adjusting bolts
anticlockwise as it may be required.
> Remount the bottom plinth or grille.
2
1
[ 2 ] clockwise or

4. PANELS MOUNTING

INTEGRATED SERIES
4.1 Decorative door and bottom-drawer
panels layout
The dimensions of the panels are indicated in the
table and drawings on next pages.
Nevertheless, according to the requirements for
aligning with other kitchen structures, the door
panel can be higher than the upper edge of the
refrigerator door, and the drawer panel can be
lower than the edge of the drawer.
The panels must be mounted using special bra-
ces which attach to adjustable devices provided
on the door and drawer and with brackets that
anchor and adjust the panel's vertical direction.
Braces, brackets and fixing screws are provided
with the appliance and must be applied to the pa-
nel as indicated.
Operate as follows:
To prepare the panels to be mounted on the ap-
pliance, follow these steps, working on the back
of the panel.
Door Panel
> Trace, a line dividing the panel width in half
> Starting form the Bottom edge of the panel,
mark the positioning of the brackets
2
EN
[ 1 ].
1
[ 2 ].
13