Herunterladen Inhalt Inhalt Diese Seite drucken

Hints And Tips; Technical Specification; Selection Of Installation Equipment - Candy CEH6DXECTT/1 Bedienungsanleitung

Glaskeramikkochfelder
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 13
Spillovers on the
1. Switch the power to the
touch controls
cooktop off.
2. Soak up the spill
3. Wipe the touch control area
with a clean damp sponge or
cloth.
4. Wipe the area completely
dry with a paper towel.
5. Switch the power to the
cooktop back on.

Hints and Tips

Problem
Possible causes
The cooktop cannot
No power.
Be turned on.
The touch controls are
The controls are locked.
unresponsive.
The touch controls are
There may be a slight film of
difficult to operate.
water over the controls or you
may be using the tip of your
finger when touching the
controls.
The glass is being
Rough-edged cookware.
scratched.
Unsuitable, abrasive scourer or
cleaning products being used.
Some pans make
This may be caused by the
crackling or clicking
construction of your cookware
noises.
(layers of different metals
vibrating differently).
• The cooktop may beep and turn
itself off, and the touch controls
may not function while there is
liquid on them. Make sure you
wipe the touch control area dry
before turning the cooktop back
on.
What to do
Make sure the cooktop is connected
to the power supply and that it is
switched on.
Check whether there is a power
outage in your home or area. If
you've checked everything and the
problem persists, call a qualified
technician.
Unlock the controls. See section
'Using your ceramic cooktop' for
instructions.
Make sure the touch control area is
dry and use the ball of your finger
when touching the controls.
Use cookware with flat and smooth
bases. See 'Choosing the right
cookware'.
See 'Care and cleaning'.
This is normal for cookware and
does not indicate a fault.
EN-15

Technical Specification

Cooking Hob
Cooking Zones
Supply Voltage
Installed Electric Power
Product Size L×W×H(mm)
Built-in Dimensions A×B (mm)
Weight and Dimensions are approximate. Because we continually strive to
improve our products we may change specifications and designs without prior
notice.
Installation

Selection of installation equipment

Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be
preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select
heat-resistant work surface material to avoid larger deformation caused by
the heat radiation from the hotplate. As shown below:
L(mm)
W(mm)
H(mm)
590
520
52
Under any circumstances, make sure the ceramic cooker hob is well ventilated
and the air inlet and outlet are not blocked. Ensure the ceramic cooker hob is in
good work state. As shown below
CEH6DXECTT/
1
4 Zones
220-240V~, 50-60Hz
6039-7186W
590X520X52
560X490
D(mm)
A(mm)
B(mm)
48
560
490
+5
+5
EN-16
X(mm)
50 mini

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis