Air Conditioner Connection (Optional) - Dometic SL12-100 Montage- Und Bedienungsanleitung

EN
CAUTION! Damage hazard
All cables of power connections must have a minimum cross-section of 25 mm², or in any case, the cross-
section must be matched to the required length of the cable.
5. Connect the starting battery positive
fig.  on page 2
6. Install and tighten the three M6 nuts.
7. Loosen the two pin terminal screws.
CAUTION! Damage hazard
To prevent damage to the equipment, the house battery negative must be connected at the end of the in-
stallation.
8. Connect the D+ signal wire to pin
fig.  on page 3
9. Tighten the two pin terminal screws.
Note If the device is connected correctly, it should emit an acoustic signal.
10. If the device does not emit an acoustic signal, press the On/Off switch.
fig.  on page 3
11. Install the lid and secure it with the two screws.
12. If the vehicle is equipped with a smart alternator (Euro-6), bridge connectors
cable.
fig.  on page 4
Note Connecting the jumper cable to either of the two connectors activates the smart alternator
mode.

9 Air conditioner connection (Optional)

To establish a connection between the device and an air conditioner, the wiring of the supplied 3-pin connector is
necessary. The wiring configuration of the connector depends on the air conditioner model. The management of an
air conditioner requires only two of the three pins of the connector to be used.
fig.  on page 4
The following table shows which pins should be used depending on the air conditioner model.
Dometic CA1000, CA2500
Dometic B2200, B2600
10
, the inverter positive
and the house battery negative wire to pin
Air conditioner
Dometic FreshJet
and the house battery positive cables
.
and with the supplied jumper
Normally open
Common
Normally closed
Pin configuration
-
-
-
.