Cleaning And Maintenance; Disposal/Recycling - HSM StoreEx HDS 230 Betriebsanleitung

english

10. Cleaning and maintenance

Cleaning
CAUTION
Cleaning the device
When cleaning, do not allow water to penetrate
the device.
Only with a soft cloth and a mild soapy water
solution to clean the device. Do not allow
water to penetrate the device when cleaning.
If water penetrates the device, notify HSM
customer service.
The use of:
• Scouring agents
• Benzine
• Petrol
• Thinners
is prohibited.
Maintenance
WARNING
Authorised personnel for service work
Service work may only be carried out by
the HSM Customer Service or by HSM
service technicians of our contractual partners.
Lubrication of the synchronous wheels is
an exception.
The synchronous wheels must be lubricated
after 170 operating hours or with semi-annual
frequency by the operator / owner.
To lubricate the synchronous wheels,
proceed as follows:
• Switch the device off .
• Open the maintenance fl ap.
• Screw the tube containing the grease to the lu-
brication nipple.
This document shredder meets the applicable harmonisation legislation of the European Union:
• Low Voltage directive 2014/35/EU
• EMC directive 2014/30/EU
• RoHS directive 2011/65/EU
The EU declaration of conformity can be requested from the manufacturer.
28
• Squeeze the grease out of the tube.
Required amount for semi-annual:
15-20 ml/ gr.
• Close the maintenance fl ap.
• Turn the device on again.
Lubricate the synchronous wheels with
the following grease (recommended):
• K2K in accordance with
DIN 51502 / DIN 51825.
1
Position description of components
1. Lubrication nipple

11. Disposal/Recycling

Dispose of the device in an environmentally
friendly way at the end of its service life.
• Pay attention to the currently applicable direc-
tives.
• Since the legal situation is always subject to
change, please contact your local authority at
the appropriate time.
As the manufacturer, HSM would be pleased to
advise you concerning the disposal of your old
device.
StoreEx HDS 230
NOTE
09/2021