Operator Control Panel; Preparing For Operation; Switching The Device Off - HSM StoreEx HDS 230 Betriebsanleitung

Preparing for operation

• Put the main switch into the "I" position.
• The last kind of material that was selected ap-
pears in the display fi eld: Hard drive, CD/DVD
or magnetic tape.
If the last kind of material to be selected is to be
shredded again, press the button:
• The shredding data media is schematically ani-
mated in the information pane. If the hand icon
appears in the display fi eld and the status bar
turns red, the device is not ready for operation.
Do not put in any material.
• The hand icon in the information pane
disappears and the status display turns green
if the device is ready for operation. Put in
material.
NOTE
For more information about operating
the device and the operator control panel,
see chapter Operator control panel.
Ending material shredding
Button(s) Action
Stop button stops / ends
the material shredding.
Switching the device off
• Move the main switch into the "O" position.
NOTE
Safeguard the device from unauthorised use
after switching off .
Main switch is in position "O" and is secured
with a padlock.
24

8. Operator control panel

Sensitive operator control panel
Operating the operator control panel with
pointed objects can cause damage.
• Do not use pointed objects during operation.
2
Operator control panel description
1. Display fi eld
2. Menu button
3. Two-colour LED (green / red)
4. Enter key
5. Control buttons
6. Stop button
StoreEx HDS 230
CAUTION
1 3
6 5 4
09/2021