Initial Start-Up; Operation; Switching The Device On - HSM StoreEx HDS 230 Betriebsanleitung

english

6. Initial start-up

DANGER
Risk of electric shock
Improper handling of the device
can lead to electric shocks.
• Initial start-up may only be
carried out by a qualifi ed
electrician.
• The machine must only be
operated in dry rooms indoors.
• Keep the device and the power
plug away from hot surfaces and
naked fl ames.
• The voltage and frequency of your power
supply must match the specifi cations on
the type plate of the device.
• During initial start-up, ensure that
the power plug is unobstructed and cannot be
trodden on.
• Always connect the device to a properly in-
stalled socket.
• Before initial start-up, check that the safety
equipment of the device is present, undamaged
and functional. Do not start up the device until
all safety equipment has been installed properly
and is fully functional.
• Take the device out of operation in the event of
faults or damage to the safety equipment.
4 x
Version with drawer:
Fit the drawer and secure it with the 4 screws.
22
Version with conveyor belt:
Install the conveyor belt and fasten it with the 4
screws. The conveyor belt can be installed on the left
or right.
Plug in the cable for the container sensor or convey-
or belt under the main switch.

7. Operation

Before operation, the operator must have
read and understood the entire operating
manual, particularly the Safety chapter.

Switching the device on

• Put the main switch into the "I" position.
StoreEx HDS 230
4 x
NOTE
09/2021