Programming - Somfy Dexxo Optimo Rts Installationsanleitung

Dexxo Optimo RTS
3.1 Installation height - Fig. 3
-
the ceiling.
-
3.2 Detailed description of installation steps -
Fig. 4 to 14
Mounting the lintel bracket and the door bracket (Fig. 4)
by up to 200 mm max (Fig. 4- ).
Assembling the two part rail (Fig. 5)
[1]. [2]. [3].
Ensure that the chain or belt is not twisted.
[4].
[5]. Mount the complete assembly using the eight mounting screws.
[6]. Tighten the nut to tension the chain or belt. The compressed rubber must
mounting screws.
Fitting the rail onto the motor head (Fig. 6)
Fitting to the lintel bracket (Fig. 7)
Ceiling mounting
Fig. 8).
It is possible to add mounting points at the motor head level (Fig. 8 -
- mount the system at the motor head (Fig. 9 -
- mount the system at the rail (Fig. 9 -
(Fig. 9 - ).
Fitting the arm onto the door and the trolley (Fig. 10)
In case the handle release system is positionned greater height than
1,80 m, it will be necessary to lenghten the cord to make it accessible
to all end-users.
[1]. Release the trolley using the manual release cord.
[2]. Bring the trolley up to the door.
[3]. Attach the arm to the door bracket and the trolley.
Adjusting and fastening the opening travel stop (Fig. 11)
[1].
mechanism and bring the door to the open position.
At this step, make sure that the cord from the manual release system
could not be caught afterwards in a prominent part of the vehicule
(i.e. roofbars).
travel stop.
[2].
[3]. Position the travel stop against the trolley.
[4]. Moderately tighten down the mounting screw.
Do not tighten the mounting screw all the way down. Excessive
tightening can damage the screw and cause the travel stop not to
remain in place.
Fitting the chain retainer pads (Fig. 12)
For chain rails only.
).
a
)
b )
Make sure that the pad is pressed in all the way so that its positioning pin is
Checking the chain or belt tension (Fig. 13)
tensioning.
The rubber or tension spring must never be fully compressed during
operation.
Connecting the mains power supply (Fig. 14)
Plug the power cable into a suitable power outlet that complies with
electric power requirements.

4 - PROGRAMMING

4.1 Programming button description
P0
P1
Légendes voyants
éteint
Buttons Function
-
-
select a setting value
-
-
-
- Stop learning
-
-
-
-
P0 -
P1
4.2 End limit setting and self-learning - Fig. 15
[1]. SET
- the
[2].
system runner moves to link up with the trolley and closes the door.
-
direction.
Release the "-" button before the motor has time to force against the
door.
-
direction.
[3].
Release the "-" button before the motor has time to force against the
door.
[4]. SET
The door runs through a complete Open Close cycle and the
light goes out.
-
stays on.
-
+
SET
PROG
clignotant
+ -
- moves the runner in the close
+ moves the runner in the open
+ "-" buttons.
indicator light
EN
indicator
indicator