Engenius EP800H Bedienungsanleitung Seite 9

c. Once the feature code is being programmed, you can quickly
perform those functions during the call by pressing
18. Menu Display
a. To avoid mis-setup in the "Call Settings"(MENU-4), "Phone Settings"
(MENU-5), "Base Settings" (MENU-6) and Multi-base Setting
(MENU-7-3), these settings can be hidden.
b. Handset password is required before enter Menu Display (MENU-8),
the default handset password is "0000".
c. When disabling the settings, these setting will not displayed any
longer, unless enabled by entering Menu Display again.
19. PA On/Off
a. Enable or disable the broadcast function.
b. When PA is Off, the handset can't receive broadcast from base
station or other registered handsets; But it can broadcast to base
station or other registered handsets.
20. Group Setting
a. Allow handset to subscribe to one or several groups.
Re: Up to 9 groups (91~99) can be subscribed.
21. Custom Name
a. Allow changing the "EP800H" screen to the desired wording or info,
such as the user's name.
Re: Up to 32 characters can be entered.
22. Change Pwd
a. Allow changing the handset password which requires entering in Call
Barring (MENU-4-3) and Menu Display (MENU-8) .
Re:Default is "0000".
23. DTMF Duration
a. From MENU-6-1 to select variable duration of DTMF tone.
b. Default is 100ms.
c. When entering the Base Settings, PIN is required. Default is "0000".
Re: Better to check with your phone company first before changing it.
24. Programmable Flash key timing
a. From MENU-6-2 to select flash key timing
OPTION soft key.
~17~
b. 9-level (100 ms - 900 ms) timing selections, default= 600 ms.
c. The default value (600 ms) works in most areas. Changing this
setting may cause Flash key not working. Change only when you
are certain of the new value would work.
d. When entering the Base Settings, PIN is required. Default is "0000".
25. Assign next handset ID for new handset
a. Using registered handset from MENU-6-3 to assign a next handset
ID to a new handset.
b. If not assign next handset ID, the system will automatically assign a
handset ID to a new handset..
c. When entering the Base Settings, PIN is required. Default is "0000".
26. Clear Handset
a. Using registered handset from MENU-6-4 to remove the other
registered handset, in case the other registered handset is defected.
b. Once clear the other registered handset, the user is able to register a
new handset for instead.
c. When entering the Base Settings, PIN is required. Default is "0000".
27. Change PIN
Allow changing the base PIN which requires entering the "Base Settings"
(MENU-6-5).
a. Using registered handset to change PIN from MENU-6-5.
b. Default PIN is "0000".
c. When entering the Base Settings, PIN is required. Default is "0000".
28. Auto Hang Up feature
a. Using registered handset from MENU-6-6 to turn on/off the Auto
hand up feature.
b. If turning on the feature, the handset will automatically hang up the
call when the far-end hangs up the call.
c. When entering the Base Settings, PIN is required. Default is "0000".
29. Area Code
The area code function allows calls within local and country area codes
to be dialed without the prefix.
a. Enter MENU-4-7-1 to set the "Local" area code.
b. Enter MENU-4-7-2 to set the "Country" area code.
Re: Up to 3 digits can be entered.
30. Multiple Base setting
a. Up to 4 base stations can be set in one system.
~18~