Phonebook Operations - Engenius EP800H Bedienungsanleitung

After the call transferred to destination handset, the
original handset will go back to standby mode
automatically.
Notes: If the destination handset does not answer after handset
paging or transferring timeout, the call is routed back to the
originating handset.

Phonebook Operations

1. You can store up to 50 entries in the phonebook.
Each entry can contain a phone number or handset ID
(up to 26 digits) and a name (up to16 characters).
2. To access the phonebook, press
key, followed by 2 ; or press
the handset is in standby mode.
3. To add a new entry:
a. Press ADD (Left) soft key.
b. Enter the name when LCD prompts "Name?" Use
DELETE (Right) soft key to delete the last digit
entered. When completed, press
key to save.
Re: Up to 16 characters can be entered as the
name.
c. You will then be prompted to enter a number for the
name just entered.
Re: Up to 26 digits can be entered as the number.
d. After entering the number, press the
soft key to save this entry into phonebook.
e. Enter a phonebook entry without a name, the all
records without name will be placed on top of the
phonebook list.
f. To enter the name, press the corresponding
MENU (Right) soft
scrolling key while
Name?
_
SAVE (Left) soft Caps = *
SAVE
DELETE
Number?
_
SAVE (Left)
SAVE
DELETE
~35~
keypad number one or more times according to the
order of the character on the key.
See table below for a list of available characters
and their orders. For example, press
the character "A", twice for "B", etc.
Notes:
1.
When enter a phone number, the cursor automatically advances to
the next digit field. Use or
cursor backward or forward to insert or delete (the digit above the
cursor, or left of the cursor if cursor is on the right of the last digit).
2.
When entering a name, the cursor automatically advances to the
next character field if you press a different key for the next character.
If you need to enter consecutive characters from the same key, you
can wait for the cursor to advance or use
to move the cursor backward or forward manually. Also use
or to move the cursor to insert (to the left of the cursor) or
delete (the character above the cursor, or left of the cursor if cursor
is on the right of the last character).
3.
By default, all letters are entered in the upper case. Use the * key to
toggle between upper and lower cases.
4.
A "Pause" entry represents a 1 second delay in dialing the following
digits, which is useful when calling a sequence of segmented
numbers (e.g., access code, credit card number, auto-attendant
entries, etc.) Pause is entered by pressing the ＃ key twice (LCD
displays P). Entering pause twice (PP) will result in 2 seconds pause
in the dialing.
~36~
2 once for
scrolling key to move the
or scrolling key