Waste Disposal - Extol 8891590 Bersetzung Der Ursprünglichen Bedienungsanleitung

IX. Storage
y Store the machine in a dry location that is out of reach
of children at temperatures up to 40 °C with the battery
removed. Protect the machine against direct sunlight,
rodents and sources of radiant heat.
y Protect the battery against rain, frost, high humidity,
temperatures above 50°C, against mechanical damage
(e.g. being dropped) and never open or burn it.
Store the battery fully charged and to ensure the
longest possible lifetime fully charge it after several
months (no later than after 6 months).
EN
X. Waste disposal
PACKAGING MATERIALS
y Throw packaging materials into a container for the
respective sorted waste.
ELECTRICAL EQUIPMENT AND BATTERIES
AT THE END OF THEIR LIFETIME
y According to Directive (EU) 2012/19,
an unusable electrical appliance
must not be thrown out with
communal waste, but rather must
be handed over for ecological disposal at an electri-
cal equipment collection point because it contains
components that are hazardous to the environment.
The battery must be removed from the electrical
equipment, prior the equipment being handed over
for ecological disposal, at a battery collection point
separately (pursuant to Directive 2006/66 EC). You can
find information about electrical equipment waste and
battery collection points and collection conditions at
your local town council office or at your vendor.
XI. Warranty period
(rights relating to faulty
performance)
WARRANTY AND POST-WARRANTY REPAIRS
To exercise the right to a warranty repair of the product,
please contact the vendor from whom you purchased
the goods.
You can also contact our authorised service centre for
post-warranty repairs. Nearest service centre locations
can be found at www.extol.eu.
78
ES Declaration of Conformity
Subject of declaration - model, product identification:
Extol® Premium 8891590
Battery-powered wheelbarrow
Manufacturer Madal Bal a.s. Bartošova 40/3, CZ-760 01 Zlín • Company ID No.: 49433717
hereby declares
that the product described above is in conformity with all relevant stipulations of harmonisation legal regulations of
the European Union:
2006/42 ES; (EU) 2011/65; (EU) 2014/30;
This declaration is issued under the exclusive responsibility of the manufacturer.
Harmonisation norms (including their amendments, if any exist),
which were used in the assessment of conformity and on the basis
of which the Declaration of conformity is issued:
EN 62841-1:2015; EN 1175:2020; EN ISO 12100:2010; EN IEC 55014-1:2021;
EN IEC 55014-2:2021; EN IEC 63000:2018.
The technical documentation (2006/42 ES was drawn up by Martin Šenkýř at the business address of Madal Bal a.s.,
Průmyslová zóna Příluky 244, 760 01 Zlín, Czech Republic.
The technical documentation (2006/42 ES) is available at the aforementioned business address of Madal Bal, a.s.
Place and date of issue of ES Declaration of Conformity: Zlín 17.6.2022
On behalf of Madal Bal, a.s.
Martin Šenkýř
Member of the Board of Directors
79
EN