Securepoint RC100 G5 Installationsanleitung Seite 41

Step 4.4: Cable modem with DHCP:
No further entries are necessary here.
Step 5: DMZ
Configure the IP address and network mask for the DMZ interface of the
gateway. Here, too, it is possible to activate the DHCP service for the DMZ
network. In addition, you can activate the default port filter rules for the DMZ
network using the second slider.
If your appliance has a wifi module and in step 2 no WLAN bridge with the
internal network has been established, you can use the lowest slider to create
a bridge with the DMZ network here.
Step 6: WLAN
If your appliance has a wifi module, further configuration options are available:
Step 6.1: WLAN without bridge
Enter the IP address and the netmask for the WLAN interface of the gateway.
Select the country code from the drop-down menu and enter a freely
selectable SSID. Specify whether the SSID should be visible to all devices
(SSID Broadcast).
- 41 -