Maintenance And Troubleshooting - Exodraft Rbv1 Montageanleitung

38 • UK
4.8

Maintenance and troubleshooting

The RBV1 must be inspected at least once a year in connection with inspection of the chimney. Soot and other deposits
must be removed from the rotor blades and from the bottom of the motor housing.
WARNING
Do not open the RBV1, unless the power supply is switched of at the power switch.
The surface can be warm.
4.8.1 Cleaning intervals for the RBV1
It is extremely important that the RBV1 be kept free of soot and
deposits. Soot is the primary cause of chimney ires.
The RBV1 must be cleaned and inspected at least once a year
The cleaning frequency depends on how often, the stove and
RBV1 are used. Frequent use means frequent cleaning.
Regular use of the stove may require more frequent cleaning of
the RBV1.
NOTE
The RBV1 must be cleaned by someone with professional knowledge.
When cleaning, you need to ensure that there is free passage for rainwater through all drainage holes. The
manufacturer cannot be held responsible for water penetration into the chimney.
4.8.2 Troubleshooting
Observation
No power supply to the
RBV1
The power supply to the
RBV1 is on, but it's not
working
The power supply to the
RBV1 is connected, but
it hums and does not
spin
The RBV1 seems to be
working ine, but there
is not enough draft
The RBV1 vibrates
There are audible me-
chanical noises
Problem
• The switch is of
• Poor electrical connections
• Poor electrical connections
• Worn-out battery in the remote
control
• No reaction when activating the
on / of on the remote control
• Soot may block the RBV1
• Too much false air is draged in
• The motor shaft may be bent
• Foreign objects may have be-
come attached
• The motor bearings may be
worn-out
3200977-RBV1-DK-SE-NO-UK-DE
Solution
• Check the switch
• Check and remedy the problem
• Check and remedy the problem with the
connections
• Change the battery
• Reduce the distance between the wireless
outlet and the remote control
• Clean the RBV1
• Inspect for leakage in the luerun and chim-
ney
• Replace the RBV1
• Remove foreign objects
• Replace RBV1