Technical Specifications - Kärcher BR 30/15 C Bedienungsanleitung

Suction turbine does not run
 Reset the suction turbine fuse on the
control panel.
Insufficient vacuum performance
 Clean the vacuum bar.
 Check, clean or replace the seal on the
dome.
 Empty the waste water tank.
 Insert the suction hose properly on the
dome.
 Check the suction hose for damages.
No water exiting from nozzle
 Set the appliance switch to normal op-
eration.
 Fill the fresh water tank with hot water
(max. 60°C) and rinse the nozzle. Re-
place the nozzle as applicable (see
"Maintenance task/replace nozzle").
 Fill up fresh water reservoir.
 Clean the sieve in the fresh water reser-
voir.
Brush does not turn
 Set the appliance switch to normal op-
eration.
 Reset the brush drive fuse on the con-
trol panel.
 Check the drive belt, replace if required.
Carpet gets too wet
 Replace the worn nozzle with a new
one (see "Maintenance task/replace
nozzle").

Technical specifications

Power
Nominal voltage
Type of protection
Average power con-
sumption
Suction engine output W
Brush engine output
Cleaning brushes
Working width
Brush diameter
Brush speed
Detergent pump pres-
sure
Detergent pump flow
rate
Max. water tempera-
ture
Vacuuming
Cleaning power, air
quantity
Cleaning power, nega-
tive pressure
Dimensions and weights
Theoretical surface
cleaning performance
Fresh/waste water
tank volume
Length
Width
Height
Typical operating
weight
Noise emission
Sound pressure level
(EN 60704-1)
Machine vibrations
Vibration total value
(ISO 5349)
– 6
EN
V/Hz 220...240/
1~50/60
IPX4
W 1300
1130
W 76
mm 260
mm 65
1/min 1650
MPa 0,4
I/min 1,4
°C 60
l/s 46
kPa 30,2
m²/h 100
l 15/17
mm 920
mm 360
mm 750
kg 52
dB(A) 77
m/s² 1,7
15