Sony VPL-PHZ51 Installationsanleitung Seite 35

On Illumination
To obtain the best picture, the front of the screen
should not be exposed to direct lighting or
sunlight.
On Heat Dissipation
The temperature of the projector cabinet may
increase during or immediately after use;
however, this is not a malfunction.
On Screen
When using a screen with an uneven surface,
stripes pattern may rarely appear on the screen
depending on the distance between the screen
and the unit or the zooming magnifications. This is
not a malfunction of the unit.
On Fan
Since the projector is equipped with a fan inside to
prevent internal temperature from rising, there
may be some noise. This is a normal result of the
manufacturing process and does not indicate a
malfunction. If, however, in a case of abnormal
noise, consult with qualified Sony personnel.
About the Light Sensor
This unit has a function that uses the light sensor
to detect the brightness of the surroundings to
perform automatic image quality correction.
Light sensor
Do not block the light sensor when using
automatic image quality correction based on the
ambient brightness.
On inspection of light source related parts
Since the unit uses a laser, when performing
maintenance or inspection of light source related
parts, particular attention and a safe environment
are necessary. Be sure to consult with qualified
Sony personnel.
On disposing used products
Do not dispose the used products and general
garbage together.
Correctly dispose of used products to avoid
harming the environment or the health of yourself
and others. Follow the disposal regulations of your
area.
LCD Projector
The LCD projector is manufactured using high-
precision technology. You may, however, see tiny
black points and/or bright points (red, blue, or
green) that continuously appear on the LCD
projector. This is a normal result of the
manufacturing process and does not indicate a
malfunction.
Also, when you use multiple LCD projectors to
project onto a screen, even if they are of the same
model, the color reproduction among projectors
may vary, since color balance may be set
differently from one projector to the next.
On condensation
If the room temperature where the projector is
installed changes rapidly, or if the projector is
moved suddenly from a cold to a warm place,
condensation in the projector may occur. As the
condensation may cause malfunction, be careful
in adjusting temperature settings of the air
conditioner. If condensation occurs, leave the
projector turned on for about two hours before
use.
Notes on security
SONY WILL NOT BE LIABLE FOR DAMAGES OF

ANY KIND RESULTING FROM A FAILURE TO
IMPLEMENT PROPER SECURITY MEASURES ON
TRANSMISSION DEVICES, UNAVOIDABLE DATA
LEAKS RESULTING FROM TRANSMISSION
35
GB