Stocker Magma E-100 TR Benutzerhandbuch Seite 70

11
Problems Causes
1. The battery is out
of power
2. The battery is
not connected
Lopper will not start
3. Safety lock of the blade
cannot be unlocked
4. On/off switch failure
1. Loose internal
Intermittent operation connections
2. On/off switch failure
1. The blade is not sharp
2. There is a gap between
Hot blades blades
3. Poor lubrication, resulting
in excessive friction
138
Art. 612 / Art. 613
Lopper Magma E-100 and E-140 TR
Troubleshooting
Solutions
1. Charge the battery.
Instructions on page 126.
2. Check that the battery is inserted
correctly. When connected correctly,
it makes a „click" sound.
3./4. Send to repair service center by
local authorized reseller or Stocker Srl.
1./2. Send to repair service center
by local authorized reseller or
Stocker Srl
1. Sharpen the blade or replace it.
Instructions on how to sharpen the
blade on page 133, on how to replace
the blade on page 132.
2. Adjust the gap between the
blades. Instructions on page 132.
If the adjustment doesn't solve
the problem, replace the blade.
Instructions on how to replace the
blade on page 132.
3. Carry out the lubrication process.
Instructions on page 132.
Art. 612 / Art. 613
Lopper Magma E-100 and E-140 TR
Troubleshooting
Problems Causes
1. Poor lubrication,
resulting in excessive
friction
2. The blade is dirty
3. The blade is not sharp
Poor trimming
4. Incorrect trimming
performance
tecnique
5. The battery is not fully
charged
1. The battery is not properly
placed in the charger
2. The battery charger is
not connected properly to
the power supply
The battery will not
3. The contact point of the
charge. Charger
battery or of the battery
red light flashes.
charger is dirty
4. Defective or damaged
battery or battery charger.
For assistance and service, please contact your local authorized reseller or Stocker Srl.
For further information about the product, please contact info@stockergarden.com
11
Solutions
1. Carry out the lubrication process.
Instructions on page 132.
2. Clean the blade. Instructions on page 131.
3. Sharpen the blade or replace it.
Instructions on how to sharpen the blade
on page 133, on how to replace the blade
on page 132.
4. Carefully read operating instructions
in the "Usage" section.
5. Check the battery charge level.
Instructions on page 130.
1. Check that the battery is placed
correctly. When connected correctly, it
makes a „click" sound.
2. Connect correctly.
3. Clean with a dry cloth.
4. Try recharging the battery by inserting
it into both sockets of the battery
charger. If only one of the two inputs
charges, the other input is damaged or
defective.. Contact your local authorized
reseller or Stocker Srl for spare parts.
139