Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1624.10
1685.10
Typ/
Teile-Nr.
Teile-Nr.
Type
Part-No.
Part-No.
Pos.
Référence
Référence
1
108 135
108 136
2
102 159
102 159
4
102 162
114 197
5
102 163
102 163
6
102 166
102 166
7
102 167
102 167
8
102 164
102 164
9
100 057
10
102 152
102 152
11
102 174
102 174
12
101 137
101 137
13
101 398
101 398
14
108 125
15
100 203
100 203
16
100 457
100 457
17
100 463
100 463
18
100 361
100 361
19
100 369
100 369
20
100 721
100 721
21
100 264
100 264
Zahnstange: (Gesamtlänge und Ausführung, Zug oder
Druck angeben)
advise total length of rack and wether push or pull appli-
23
cation
veuillez indiquer longueur totale de la crémaillère et si
c'est pour charge en traction ou appui
12. sLIDINg DevICe TYp 6152
version: rack jack construction (see next page)
Notes on safety, installation and servicing:
The casing for the rack jacks must be securely mounted on the vehicle frame. The rack casings must also not move during operation.
The opposite drive journals on the crank drive unit must be flush.
The slide section must slide freely in the vehicle frame over the entire sliding area and must not stick.
The racks are pushed out individually and pinned and secured using bolts.
The racks must move parallel with each other in all planes.
Both parts of the connection shaft are to be pushed into each other loosely until the connection shaft can be placed on the square pin of the projec-
ting gearbox part.
Predrill both connection shaft parts together, bolt them together and secure them.
Check and ensure that the slide section slides freely by connecting and disconnecting the crank.
Lubrication:
As required, but grease adequately at least once per week.
If you have any questions, our technical support team can be contacted at any time. Tel. 09375/84-0
094002_l_gb_zstwin_s
haacon hebetechnik gmbh – Phone +49 (0) 9375 - 84-0 – Fax +49 (0) 9375 - 84-66
Abmessung/DIN-Nr.
Stück
Dimensions/DIN-No.
Qty.
Dimensions/DIN-No.
Pièce
1
1
1
1
1
1
1
1
1
1
1
1
1
M 10 x 25
DIN 933
8
A 10
DIN 127
8
A 16
DIN 127
1
M 10
DIN 934
8
M 16
DIN 934
1
A 14 x 1
DIN 471
1
AS 6 x 1
DIN 71412
1
Typ 1624.10
Typ 1685.10
6
Werbung
Inhaltsverzeichnis
