Door Opening - Fm Rx Serie Bedienungsanleitung

Click once on the recipes button.
-
Choose the program you want to edit.
-
Modify the values: time, temperature, humidity ...
-
Press the recipe button for 4 seconds until you hear a sound indicating that the program have been stored
-
properly.

Cooking phases of a program
When selecting the "PROGRAM" mode, the phase button allows you to see the steps that make up the program
(each program can have up to 3 stages). By clicking the button, you can switch from one phase to another (the F1,
F2 and F3 when illuminated, inconos will indicate which phase of the program you are). At any time we can modify
these parameters: time, temperature and humidity.

Using a stored program
To use a cooking program that is already stored is necessary to follow the next steps:
Press the "recipes" button and access the programming mode. The upper display will flash over the P01 recipe
-
(7 programs icon will light).
- With the buttons: increase or decrease choose the desired recipe and confiming the values associated with
that recipe values will appear.
- Pressing the Start/Stop button the program will starts or stops.

Various functions
 Door opening
When you open the oven door that way interrupting the cooking cycle, the number 8 icon will turn green
and the time will freeze and the oven will give pause until the door is closed again. Once the door closed
the coking cycle will resume where left off.
 Reversing turbins
The engine of the oven stops to allow changing the direction of rotation. Oven changes the direction of
rotation of motors every 96 seconds and leaving a gap of 24 seconds to stop the motors. During this 24
seconds the dumidifier is not working.
19.3 Disassembling the door for replacement (only for hinged door models)
Before disassembling the door, let the unit cool down and follow the steps below:
5. Open the door all the way.
6. Unfold the flanges on the joints and close the door partially until making contact with each groove on both flanges.
7. Remove the door by gently pulling out and upwards.
8. To assemble the door again, insert the door by placing the lower groove of the hinge on the slot of the oven body
. Then, fold the flanges again.
19.4 Changing the door opening direction (only for models RXL)
In ovens with side door opening, the door opening direction may be changed by following these instructions:
Ed.:21 – Ver.:01 – 01/01/2021
52