fm RX Serie Bedienungsanleitung Seite 50


Time adjustment
When you turn the oven on the lower display (Display time), appears END. The time range can be set between
00 hours 01 minutes - 15 hours 59 minutes.
By pressing the "up or down" buttons will allow us to set a time value. If you established a continuous cooking
mode, must press the decrease button until "INF" appears in the display button.
If you have chosen the time INF means that "an infinite set time" the oven will operate until you press the
Start/Stop button.
When editing the values are always displayed on the screen flashing. To confirm them wait 5 seconds until
stop flashing or press 3 second the button. Once confirmed, fixed values are displayed on screen.
If the program has several phases, and we need to disable one of the phases, simply adjust the time value
END for the phase we want to eliminate.

Humidifier adjustment
During cooking cycle, continued pressure on the moisture button, allows the activation of the water solenoid,
and the direct injection of moisture.
To set humidity by percentage, when setting the cooking parameters in a manual program or in programming,
press the humidity button. At this time, "oFF" will appear in the lower display flashing. Pressing the increase or
decrease button allows you to enter the desired humidity value. Humidity range: 0% - 100%. To confirm, press again
on the humidity button.
If you confirm, the humidity value of the display disappears and the cooking time will appear.
When you press the Start / Stop button to start a cooking cycle, if the cycle has a humidity percentage
programmed, for example, 10% to 100%, it will not start injecting water until the actual temperature of the cooking
chamber has exceeded 85 ° C. When humidification is active, the humidity icon will light green permanently when
you perform each injection.
During the injection of steam humidifier, icon will light up on the screen. In case that the water injestion
coincide with the reversal of the engine, it not will inject water, till its finish the complete direction.

Automatic preheat
Automatic preheating allows us to preheat the oven before starting the cooking cycles to always ensure that
the oven is at the desired temperature to start cooking. In this way we will compensate for the loss of temperature
that exists since we opened the door and loaded the food. To start the cycle it will only be necessary to open the
door, introduce the food and close the door and immediately after that time will begin to be discounted.
When the "PRE" symbol is lit, it means that the oven will preheat before cooking. During this, the oven will
rise 30ºC above the set setpoint temperature. Once the preheating is finished, the equipment will emit an acoustic
signal warning that we can already introduce the product into the oven.
To activate the preheating, we must press the time key for three seconds, before starting cooking.
To deactivate the preheating, it can be done by pressing the time button for three seconds, at the moment
that we are configuring the cooking parameters, or opening and closing the door once the cycle has already begun.
Ed.:21 – Ver.:01 – 01/01/2021
50