fm RX Serie Bedienungsanleitung Seite 49

6. PROGRAMS icon

It lights red to indicate that you have entered programming mode.
7. OPEN DOOR icon

Lights up in green to indicate that the door is open. It lights red to indicate that the door is closed.
8. PHASES icon

Visible only while cooking program in on. F1, F2 and F3 lights red one by one to indicate which phase of the
program is on.

Display
9. TIME/HUMIDIFIER

With time icon on, it shows the programmed time and the remaining cooking time.

Con el icono de tiempo parpadenado, muestra el valor de tiempo programado.

With the time icon flashing, it shows the programmed time value.

Time and humidifier icons off, shows an alarm code.
10. TEMPERATURE/PROGRAMS

Temperature icon on shows the temperature programmed for cooking.

While the temperature icon flashing, shows the actual temperature of the cooking chamber (measured by
the probe value).

If all the icons are off, shows an alarm code.
19.2.2.1 Manual humidifier during the cooking cycle
When the oven is shows "off" on the upper display, everything else is off. Pressing the ON / OFF button turns
the oven on. When the oven is on, the display shows the nstantaneous temperature inside the cooking chamber
(measured by the probe value "the temperature icon flashing ") and the screen TIME/HUMIDITY shows END (timer
icon on) . Pressing the increase or decrease button, lets you set the temperature.
Pressing the timer button allows you to adjust the cooking time.
Pressing the Start/Stop button can start or stop the cooking cycle.

Temperature adjustment
When the oven is on, pressing the Increase or Decrease buttons, immediately sets a temperature value
(adjustable temperature range from 30-260 ° C)
In the first start is shown in the temperature display value of 30 °C. Upon completion of the first cycle will
flash the previously set value.
When editing values, these will be shown in the display flashing. To confirm the values you must wait 5
seconds or press the button during 3 second.
Once confirmed the values will stop flashing on the screen. Pressing ON / OFF set values will be deleted.
Ed.:21 – Ver.:01 – 01/01/2021
49