fm RX Serie Bedienungsanleitung Seite 51


Running a cooking cycle in manual mode
With the oven on and after setting the time and temperature values, by pressing and holding the time button
for 3 seconds, we will activate the preheating. Then press START / STOP to start the cycle. This will activate the
elements, fan and humidifier when you press the button. Pressing Start/Stop the cooking cycle stops at any time
and the countdown is blocked by displaying the remaining time. If the set value was the value INF display will remain
INF. If you press the Start/Stop button cooking cycle will resume where it stopped.
Durante la cocción:
In the upper display (temperature display) the actual value of the oven interior temperature measured by the
-
probe (fixed temperature icon) will be displayed.
- On the lower display (time values) is displayed the remaining time in hours and minutes (when the set value is
greater than 1 hour) and in minutes and seconds (when the set value is less than 60 minutes) .If the value is
replaced INF for a given time, the countdown will start from the value seted.
- At the end of a cooking cycle (timer icon will lights) appears in the display flashing END, fans and elements are
switched off, and an alarm will sound for 40 seconds. If during these 40 seconds, you adjust a new time, the
oven will resume operation again for the extra time added with the same settings you had set before. Otherwise
pressing the Start/Stop button the alarm will stop and the display returns to the normal screen.
Note: To extend the cooking cycle, simply press on the increase button and add time you want to
extend, then click the time button and the oven will resume the march.
5 minutes after the end of cooking if no operation on the oven is performed, this will turn off automatically. To
-
reactivate simply press the button ON / OFF
19.2.2.2 Programmed operating mode

Storing a new program
To store a new cooking program, you must follow the next steps:
Press the 8 "Recipe" button that will allow you to enter the programming mode. "Menu" will flash on the upper
-
display, indicating that it is in Manual mode. Press the decrease or increase keys to select the program you wish
to configure and save (eg P25). To confirm you can wait 10 seconds until it stops flashing or press the recipes
button. The screen will show the values associated with the recipe, without having never used it, the values that
appear are the default values (30ºC of temperature and END in time, off in humidity and phase).
- Modify the values of time, temperature, humidity ...
- To add more phases to the cooking cycle, press button 7 "phases" the phase icon will light up. (F1, F2 or F3). Then
modify the values of time and temperature for these new phases.
- Finally, hold the recipes button for 4 seconds to stored it. The memorized program will be effective with a sound
and flash the program number that we have previously chosen to store the program.
Attention!!! To run properly the programmed settings, you need to memorize the recipe, otherwise theprogram
will not start properly.
If you want to know about that recipe you are working, just click on the recipes button and the program number will
apear.
To edit a program must follow the following procedure:
Ed.:21 – Ver.:01 – 01/01/2021
51