Connection Of The Water Drain Hose - Pkm WA12-ES1415DI Bedienungsanleitung

3. Put the other end of the water inlet hose into a
bucket or into another suitable container (s. fig on
the right) and open the water tap to flush foreign
substances (e.g., dirt, sand, etc.) out of the water
pipe and of the hose. Check the water
temperature.
4. Ensure that the rubber washer
connector. Attach the curved end of the water
inlet hose to the inlet valve of the washing
machine; s. fig. on the right / 1. Tighten the water
inlet hose firmly (clockwise) to avoid leakage (s.
fig. on the right / 2).
NOTICE! Do not overtighten the water inlet hose. Overtightening of the
water inlet hose can damage the valves.

2.7 Connection of the water drain hose

The water drain hose must be installed at a height between 70 cm and 125 cm
above the floor (s. below; fig. 1, 2 and 3).
The hose outlet must not be installed less than 70 cm above the floor.
The hose outlet must not be installed higher than 125 cm above the floor.
If the water drainage hose is installed on the appliance (as shown in fig. below),
disconnect it from the right bracket only (not from the other brackets): see fig.
below.
Depending on model.
31
31 is in the valve
~ ~
99
Fig. similar