Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2-way system
With "Input Connection" (page 9) , or .
Tweeter (min. 2 Ω)
CH 1/2
FILTER
OFF
BP
HP LP
Note
When making this connection, set the settings on the
control panel (top panel) to the following positions:
• For CH 1/2:
– Set FILTER to "HP".
– Set RANGE to "500-5k".
• For CH 3/4:
– Set FILTER to "LP".
– Set RANGE to "50-500" or "500-5k" depending on your
speaker specification.
2-subwoofer system (bridged
connection)
With "Input Connection" (page 9) or .
CH 1/2
FILTER
RANGE (Hz)
OFF
BP
50-
HP LP
500
Subwoofer (min. 4 Ω)
Note
When making this connection, set the settings on the
control panel (top panel) to the following positions:
• For both CH 1/2 and CH 3/4:
– Set FILTER to "LP".
– Set RANGE to "50-500".
12
GB
CH 3/4
FILTER
OFF
BP
HP LP
Woofer (min. 2 Ω)
CH 3/4
FILTER
RANGE (Hz)
OFF
BP
50-
HP LP
500
Full range speaker system
With "Input Connection" (page 9) , or .
Front speaker (min. 2 Ω)
CH 1/2
FILTER
OFF
BP
HP LP
Note
When making this connection, set the settings on the
control panel (top panel) to the following positions:
• For both CH 1/2 and CH 3/4:
– Set the FILTER to the "OFF".
Output Connection
Through the LINE OUT connector, this amplifier can
output signals to additional amplifier. This allows a
flexible system connection that utilizes multiple
amplifiers.
Notes
• Audio signals output from LINE OUT connectors are not
affected by any signal processing, such as the HPF and LPF
settings.
• According to your needs, set the LINE OUT MODE switch
on the control panel (top panel) to "THRU", "STEREO" or
"ALL".
• Refer to the operating instructions supplied with your
additional amplifier for connection details.
CH 3/4
FILTER
OFF
BP
HP LP
Rear speaker (min. 2 Ω)
Additional amplifier
Werbung
Inhaltsverzeichnis
