Absima CR-18 PRO Bedienungsanleitung Seite 15

Specifications
Product Name: FS-R4A3-BS
Adaptive Transmitters: FS-MG43-BS
Adaptive Models : 1:18 simulation cars, climbing cars
Number of Channels: 4
Number of Lights: 7
RF: 2.4GHz ISM
2.4G Protocol: 2A-BS
Antenna: Single antenna
Input Power: NiMH (5~7Cell)/ 2S Lithium batteries
Continuous/Peak Current: 10A/50A
Overview
[12]
[13]
[14]
[15]
[16]
[1] CH1
[2] CH3
[3] CH4
[4] Headlight interface
[5] Right turn signal light interface
[6] Fog light interface
[7] Fog light interface
[8] Left turn signal light interface
Binding
The receiver automatically enters the binding state once it is powered on. Follow the steps below to bind
with the transmitter.
1. Power on the transmitter while pressing the BIND button, then the transmitter enters the binding mode.
At the time, The G.LED on the transmitter flashes quickly, then release the BIND button.
2. After the receiver is powered on, it will automatically enter the binding mode if it is not connected to
the transmitter in 1 second;
3. After the binding is finished, the LED of the receiver is solid on.
Notes: Put the transmitter into binding mode first, and then put the receiver into its binding mode. If the
binding is not finished within 10s,
the LED of the receiver will enter its slow flashing state.
[10] [8]
[9]
[11] [7] [6]
[5]
[4]
[3]
[2]
[1]
[17] [18] [19] [20] [21]
[9] LED
[10] Headlight interface
[11] Antenna
[12] Power switch
[13] Battery line anode
[14] Battery line cathode
[15]Motor interface "M+"
[16] Motor interface "M-"
Data Output: PWM
Temperature Range: -10℃ ~ +60℃
Humidity Limit: 20%~95%
WaterProof: PPX4
Distance: >150m(Ground distance without inference)
Online Update: NO
Dimensions: 33mm*30mm*12mm (Excluding capacitor)
Weight: 11g
BEC Output: 6V/1A
Certification: CE, FCC
[22]
[17] Left turn signal light interface
[18] Right turn signal light interface
[19] Tail light interface
[20] Stop light interface
[21] Backup light interface
[22] Channel signal end
[23] Power anode
[24] Power cathode
[23]
[24]