Absima CR-18 PRO Bedienungsanleitung Seite 18

ESC function instructions
1. Connect related equipment:
• Make sure the ESC is off before connection. Connect the motor with M+ and M- of ESC. Connect the
steering servo to the 3Pin interface marked with "ST" of ESC (- + S connected correspondingly).
Connect the battery with the positive and negative poles of ESC correspondingly.
2. Normal boot, identification throttle midpoint:
• After connecting related equipment as step 1, turn on the radio first, move the throttle trigger to the
neutral position. Turn on the switch of ESC at last. The receiver will automatically recognize the battery
type when is powered on again. Then it can run it.
Notes:
a. The ESC can be run after completing self-inspection (about 3 seconds) if power on, otherwise it cannot
be operated normally.
b. If there is no power output and the red light of ESC flashes quickly after power on, please check whether
the throttle trim of the transmitter is set to the "0" position. the receiver will automatically recognize the
midpoint of the trim throttle after restarting;
c. If the rotation direction is not correct during running, exchange the two wires connecting motor and ESC.
d. To make sure everything is ok, please turn on the transmitter first and finally turn on the ESC, turn off
the ESC first and finally turn off the transmitter.
Note: Please refer to the relevant sections for details about the battery type, drag brake force and running
mode of the ESC.
Attention:
• Make sure the product is installed and calibrated correctly, failure to do so may result in serious injury.
• Please carefully check each power device and car frame instructions to ensure the power matching is
reasonable before use. Avoid damaging power system due to incorrect matching.
• Do not let the external temperature of the system exceed 90℃ /194 ℉ , because high temperature will
damage the power system.
• Make sure the receiver's battery is disconnected before turning off the transmitter, failure to do so can
result out of control. Unreasonable setting of the Failsafe may cause accidents.
• After use, remember to disconnect the battery and the ESC. If the battery isn't disconnected, the ESC
will consume electric energy all the time even if it is off. It will discharge completely if connect the
battery for a long time, thus resulting in the failure of the battery or the ESC. We are not responsible for
any damage caused by this!
• Make sure the receiver is mounted away from motors or any device that emits excessive electrical noise.
• Keep the antenna of the receiver at least 1cm away from conductive materials such as carbon or metal.
• Do not power on the receiver during the setup process to prevent loss of control.
Battery
Motor
LED
Servo
ESC&RX