Basic Operations - Absima CR-18 PRO Bedienungsanleitung

Basic Operations

Install the Battery
Battery Type: AAA
Battery Installation:
1. Open the battery compartment cover.
2. Insert 4 fully-charged AAA batteries into the compartment. Make sure
that the battery makes good contact with the battery compartment's
contacts.
3. Replace battery compartment cover.
Low battery alarm: When the battery is lower than 4.2V, the G.LED on the
panel will flash slowly.
Note: When installing the battery, please pay attention to the pos itive and
negative poles of the battery to avoid installation errors.（As shown
on the right）
Power on
Follow the steps below to turn on the transmitter:
1. Check to make sure that that battery is fully charged and installed correctly.
2. Toggle the switch to the [ON] position. When active the R.LED will be lit.
3. Connect the receiver to power.
For safety always power on the transmitter before the receiver.
Binding
The transmitter and receiver have been pre-bound before delivery. If you are using another receiver,
follow the steps below to bind the transmitter and receiver：
1. Turn on the transmitter while holding the bind button to enter bind mode. G.LED will start flashing
quickly.
• Once in bind mode release the bind button.
2. The receiver will enter bind mode atomically when powered on.
3. Once binding is successful the receivers and transmitter'sLED will remain solid .
Note: When binding, put the transmitter into bind mode first, then the receiver.If the Binding does not
finish in 10s, The receiver will quit bind mode automatically.
This binding information only applies to the attached receiver on the product, different receivers may require a
different pocedure to complete the binding process.
Product information is updated regularly, please visit our website: www.absima.com for more informations.